Motorcycle brakes
Derbi GP1 125

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2024-02-29, 08:21

View original

Jakub

Good quality I've been driving for 2 years now and the lining has shrunk by only about 4mm whether mud or dirt they brake perfectly I recommend ! trw pads like big dirt !!!

Review translated automatically

Reliable opinion

2018-07-14, 18:53

View original

Rafał

yamaha mbk skailainer 125 parts fit perfectly montarzu10 minutes time I am very satisfied recommend.

Review translated automatically

Reliable opinion

2019-05-24, 15:04

View original

Krzysztof

Aprilia sx 50 2010. The pads fit great.

Review translated automatically

Reliable opinion