Motorcycle brakes
Honda FX 650 Vigor

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2022-05-20, 16:49

View original

Krzysztof

BMW F650 GS 2000 Product as described, workmanship and aesthetics flawless. They work well both on asphalt and off-road, do not squeak. They do not dirty calipers, rims, lags. In the selection of pads is very helpful sketch with dimensions. I recommend.

Review translated automatically

Reliable opinion

2022-05-02, 11:27

View original

Mirosław

Honda SW T400 year 2010 automatic stop lights workmanship good, fits very well without any problem I installed. It met my expectations.

Review translated automatically

Reliable opinion