Highsider CAN-BUS CBW1 Resistor - 207-033

Name: Highsider CAN-BUS CBW1 Resistor - 207-033
Brand: Highsider
SKU: 2742974
Price: 33.36 EUR
Availability: InStock

€33.36 including VAT

Highsider CAN-BUS CBW1 Resistor

Manufacturer:	Highsider
Manufacturer id:	207-033

General description

HIGHSIDER CAN-BUS resistor CBW1 with DIP-switch.
Our newly developed HIGHSIDER CAN-BUS resistor CBW1 fits most vehicles that have a CAN-BUS system.
The CBW1 resistor provides a required electrical load for your vehicle, which, if the dip switches are set correctly, will result in no flashing of the accessory flashers in the cockpit.
In addition, a reliability is given. This means:If the accessory indicators fail due to an electronic fault, an error message is immediately displayed in the cockpit.
Up to 2 channels can be operated, such as turn signals at the rear left and turn signals at the rear right.
If 2 pairs of indicators need to be changed,also 2 CBW1 needed to be used.
Which requirements should be met in order to use the CBW1 on the motorbike:
The motorbike was originally produced with LED indicators or the motorbike has a CAN-BUS System
If these requirements are not met, the CBW1 unit will not function (!) In this case, we recommend the following resistances:
For indicators with 21 Watt:6,8 Ohm partnumber 1108546002 or 10 Ohm partnumber 1108546004
For indicators with 10 Watt:27 Ohm partnumber 1107562
The following resistance values can be set on the CBW1:
150 ohms
170 ohms
240 ohms
300 ohms
400 ohms
600 ohms
1200 ohms
Dimensions:Height = 11mmWidth = 31mm (without straps)Width = 46mm (with tabs)Length = 40mm
Cable length = 200mm with pins
Connections:Yellow = input channel 1 (+)Orange = output channel 1 (+)Blue = input channel 2 (+)Red = output channel 2 (+)Gray = input mass (-)Black = output ground (-)
Hints:– Up to 2 channels can be operated.– The connection is explained precisely in the mounting instructions!