O-ring plate of the kicker for Jawa 50 Romet Ogar 200
| Manufacturer: | Venbo |
|---|---|
| Manufacturer id: | 121502 |
- made of steel on the model of the original
- goods made in the Czech Republic
- inner diameter: 16 mm
- outer diameter: 21 mm
Gmoto.pl Paweł Cebulak, Tadeusza Kościuszki 78, 37-100, Łańcut, PL, [email protected]
Product reviews
-
Product of unknown manufacture - perhaps even Chinese - while the quality is satisfactory after installation fits into place
Review translated automatically
Reliable opinion
-
Well-fitted sits as it should only remember that under the bottom goes an oring. Also available on the site such a kit will work perfectly. Unless the shaft is badly worn then only replace the fight.
Review translated automatically
Reliable opinion
-
Jawa 50 Mustang. Fast delivery, good quality goods, good materials, good value for money. Recommended.
Review translated automatically
Reliable opinion
-
Ogar 200 88' In my opinion, this is a must-have item when replacing the kick seal. The old plate was sitting so tight , that pulling it out in a state for reassembly was impossible. The plate can be pushed into place without any problem by a long 16 mm socket. It sits securely and holds the o-ring well, which means that oil leaks stopped after replacing the o-ring and plate.
Review translated automatically
Reliable opinion
-
Fits without a problem on the factory shaft in the engine Jawa 50. When installing it, you need to pay attention to the o-ring,so as not to damage it. After installation, oil leaks stopped. Moped Ogar 200, 88 vintage
Review translated automatically
Reliable opinion
-
Jawa 50 type 20 . The workmanship of the plate is close to the original . The plate fits and performs its function!
Review translated automatically
Reliable opinion
-
Ogar 200 89 year. Fits well enters the squeeze but holds elegantly. I recommend this product
Review translated automatically
Reliable opinion
Questions & Answers
Have a question about this product?
No one has asked a question about this product yet. Be the first and get an answer from our community or experts!