Motorcycle brakes
Daelim S3 250 Advance

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2018-09-09, 18:48

View original

EUGENIUSZ

Very good quality product, no service required, I replaced it myself, and I already have a front brake stop light. I am satisfied with this product, regards - Eugene

Review translated automatically

Reliable opinion

2019-06-10, 19:14

View original

Tomasz

Hello, I own a 1986 Honda Goldwing 1200 INTERSTATE motorcycle. I replaced the sensor purchased from you myself, nothing difficult, especially since it is no different from the original, which was in the motorcycle from new. The sensor installed, the stop light works, which gives me the feeling of a safer ride. My purchases from your store will not end with just this item, as the Honda is already years old and some parts need to be replaced. Thank you for being there, my warmest regards to you all and I sincerely recommend GTMOTO.PL. WITH KINDNESS, Tomasz Majcher.

Review translated automatically

Reliable opinion

2018-11-09, 15:52

View original

Panbalcer2

I own a 1999 Honda "shadow "vt 125 chopper(recently)and the difficulty was to find the above automatic for the jc 29 a model Thanks to you, I easily installed the received automatic (works flawlessly)despite being 72 years old and having health problems.Getting to know my chopper I intend to use your services in the first place in case of need of your services Greetings panbalcer2

Review translated automatically

Reliable opinion

2020-05-09, 12:13

View original

Andrzej

In my motorcycle, the installation of pads is the proverbial 5 minutes, you can do it without removing the caliper .Pads, I bought organic because they are softer .Maybe they wear out faster, but the disc lives longer .Fitting is good, no problem and nothing needs to be adjusted.Overall I am satisfied.

Review translated automatically

Reliable opinion

2021-05-10, 16:56

View original

Przemysław

Honda Transalp XL 700 VA, year 2007 mileage 48 thousand km, automatic stop faithfully matches the original, installation did not cause any problem, fits perfectly in the mount, appearance very good, operation very good.

Review translated automatically

Reliable opinion

2025-04-13, 11:27

View original

NIKOS

Excellent product. It fit properly in the caliper and I no longer have any leakage from the wear and tear of the previous one. Tourmax quality comparable to the factory ones.

Review translated automatically

Reliable opinion

2025-07-27, 08:46

View original

Eckehard

Good product delivered quickly. I searched for a while to avoid spending so much and found what I was looking for at GMOTO. That's how it should be.

Review translated automatically

Reliable opinion

2024-11-07, 08:28

View original

Furui

Delivered as ordered. Everything in order. I would order from GMoto again. It is a reliable supplier.

Review translated automatically

Reliable opinion