Motorcycle brakes
Honda MSX 125

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2025-03-10, 19:16

View original

Matyáš

I replaced the front brake pads on my Honda CBF 125 because they were worn out and the brakes were losing their effectiveness. First I lifted the front wheel and loosened the brake caliper. Then I pulled out the old pads, which were already badly worn. I cleaned the caliper, checked the condition of the disc and put on the new pads. Once they were seated properly, I screwed the caliper back on and squeezed the brake lever a few times to get the pads to seat properly. After a short test drive, I felt that the brakes were working perfectly again.

Review translated automatically

Reliable opinion

2025-08-03, 17:44

View original

Nicholas

An absolutely worthwhile upgrade to the standard brake! The pads deliver extremely snappy and at the same time easily controllable braking power - whether cold or under prolonged load. There is no fading even when riding fast downhill or in a sporty manner, the brakes remain constantly powerful. The braking feel is much more direct, which massively increases confidence in the front wheel.

Review translated automatically

Reliable opinion

2022-10-09, 17:52

View original

Oskar

As for me this product is phenomenally made. The pads brake perfectly I am very happy with this purchase I feel more secure thanks to the fact that these pads do their job so well. Quality of workmanship at a high level.

Review translated automatically

Reliable opinion

2025-04-13, 11:27

View original

NIKOS

Excellent product. It fit properly in the caliper and I no longer have any leakage from the wear and tear of the previous one. Tourmax quality comparable to the factory ones.

Review translated automatically

Reliable opinion

2020-07-01, 12:06

View original

Kacper

Honda CBR 125 jc34 2006 In my opinion, considering the price of the product, there is nothing to complain about. Fitting 10/10 everything fits perfectly

Review translated automatically

Reliable opinion

2025-06-08, 09:19

View original

Konni

Everything went great, price / performance is top! Fast shipping. High quality product, from OEM level. Always gladly again!

Review translated automatically

Reliable opinion

2025-07-27, 08:46

View original

Eckehard

Good product delivered quickly. I searched for a while to avoid spending so much and found what I was looking for at GMOTO. That's how it should be.

Review translated automatically

Reliable opinion

2025-04-03, 08:34

View original

Philippe

Product as described (2008 Honda transalp front brake disc bolts). Delivery OK. Perfect.

Review translated automatically

Reliable opinion

2025-07-26, 11:54

View original

castel

Everything is in order, no surprises, I was able to rebuild my master cylinder without any problems! It's perfect?

Review translated automatically

Reliable opinion

2024-11-07, 08:28

View original

Furui

Delivered as ordered. Everything in order. I would order from GMoto again. It is a reliable supplier.

Review translated automatically

Reliable opinion