Motorcycle suspension - Front
Honda CB 650

2020-02-25, 22:28

View original

Johan

Used for Honda FT 500 1983. Fitted within the hour (after disassembly & preparation = removal of old bearings). Have used 50 mm pvc pipe to drive bottom cup in; tightness of fit was as it should be. Did not use the supplied washer but made my own of 30x36x3 mm so the original rubber seal could sit below the (inner part of) the bearing. Re-used the original bottom washer (0.8 mm thick) to shield the seal. The (upper) adjustment nut also carries a thin shield. I had to grind the spigot (for the shield, on the nut) to a chamfer, as it just touched the radius of the upper bearing inner ring. On the 3rd picture, where the shield lies under the nut: red arrows = grind inner dia of spigot, shield fits at outer dia (on top as depicted). Ordered a 2nd set for my Honda XBR 500.

Review translated automatically

Reliable opinion

2021-08-28, 08:02

View original

Rafał

Very good quality. Fits suspension that even the factory did not have covers, fits Suzuki Bandit GSF600 1999 (prelift). I recommend the set

Review translated automatically

Reliable opinion

2024-06-01, 13:30

View original

Kamil

Honda Hornet 600 pc34 from 2001, they fit perfectly to the lags of the motorcycle, quality of workmanship at a high level, the rubber is not old and holds very well, the sealers and anti-dust themselves come in a box, in which there are nicely separately sealer and anti-dust, in addition, the timing of implementation, shipping and delivery at a fast level, as highly recommend :)

Review translated automatically

Reliable opinion

2021-02-05, 07:32

View original

Marek

Hello, I recently purchased some bearings shown in the ad. They were mounted to the scythe in the mtd tractor. SKF bearings have good strength and fit perfectly in the places for them. The advantage of the product is all kinds of uses, they perform well in any equipment. I recommend to purchase this product. Greetings

Review translated automatically

Reliable opinion

2020-08-18, 22:09

View original

Jakub

When purchased, the bearing had no play, as befits a new bearing. The bearing has many uses. They can be mounted to wheels that are equipped with a drive on which a very high force acts. This bearing will 100% last more than a typical Chinese bearing.

Review translated automatically

Reliable opinion

2023-11-03, 08:04

View original

Adrian

Fast shipping, two days and I could continue to ride. Gaskets of good quality, nothing different from the original ones taken out of the lags. Quality/price ratio 10/10

Review translated automatically

Reliable opinion

2025-04-07, 06:20

View original

marchal

Please order in pairs! Otherwise good size Bearing looks good To be seen in time

Review translated automatically

Reliable opinion

2024-07-01, 04:58

View original

Sebastian

It's hard to give an opinion as you haven't worn and operated it yet but it's packaged nicely and looks promising

Review translated automatically

Reliable opinion