Tools and equipment for workshops
SHL M04 125

2018-01-08, 18:25

View original

Wojciech

I own a 1985 WSK 125 M06B3. The purchased wrench does not fit the exhaust elbow nut at all. It is definitely too small. In other words, the claw is too small in diameter. Not even the possibility of catching with the wrench on the cutters on the nut.

Review translated automatically

Reliable opinion

2021-03-21, 23:40

View original

Bartłomiej

The puller is made of good quality thick sheet metal, which certainly will not bend after several uses. All the holes matched, with this puller I unbolted the engine in a WSK 125 much faster than with a classic hammer and chisel. The only minor flaw I noticed was a rather large burr with which I cut myself, but a moment on the grinder and the problem was over. I highly recommend it to all WSKe owners.

Review translated automatically

Reliable opinion

2020-08-24, 13:57

View original

Sebastian

The idea for the puller and the drilling of some of the holes was excellent, unfortunately the execution is average - some of the holes need to be drilled so that the screw "six" can pass through, to make matters worse the accuracy of the holes is "so-so" - they could be made more accurate by at least 5 mm. Thus, a second revision of this puller would be useful.

Review translated automatically

Reliable opinion

2021-10-06, 08:34

View original

Łukasz

I bought the parts for my WFM 125 M06 from 1954 first models engine . Workmanship ok, but I had to drill one hole to fit into the holes in the crankcase. Express shipping , I received the parts on the second day. I recommend

Review translated automatically

Reliable opinion