Motorcycle Accessories
KTM XC-W 450 4T 2012

2024-05-06, 12:06

View original

Krzysztof

Reinforcement very solid. I installed in a KTM EXC-350.Previously I rode without and unfortunately the radiator on both sides bent during falls. Installation was no problem, especially since I had to replace the radiator with a new one anyway. Here a note - I bought a replacement "Psychic" and it differs in the number of inputs from the OEM - the manufacturer assumes that we want to give up the thermostat right away and there is one less circuit - for me this was a plus. Going back to the "back" - in the right one there is a place to install a fan. I installed an aftermarket one and although the hole is a little smaller, it was possible to fit it in.

Reliable opinion

2022-03-22, 10:27

View original

Piotr

The cover is very well fitted to the cover. I fitted it to a 2013 KTM EXC 450. I have a caveat about the bushings for the bolts and the bolts themselves. The bushing has a flange on the head side of the screw and on the side where it presses against the lid is narrow. Because of this, you can't tighten it too much because it cuts into the space around the hole. After tightening and unscrewing again, you can see the indentation in the material of the lid. As for the screws, they are of very poor material. I screwed on the original ones even though it catches a little less thread. But with not too tightening it is enough.

Reliable opinion