Motorcycle brakes
Honda CBR 1100 XX Super Blackbird 2003 - Page 2

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Reliable opinion

2024-09-20, 06:31

View original

Alexandros

Καλημερα σας, το συγκεκριμένο ανταλακτικο το εψαχνα παντου, αλλα μονο σε αυτο το κατάστημα το βρήκα. Ειμαι πολυ ευχαριστημενος απο την ποιοτητα κατασκευης σε σχεση με την τιμη του προιοντος. Αξιζει και με το παραπανω

Reliable opinion

2025-01-03, 12:40

View original

Dominik

Przy wymianie klocków uszkodziłem oryginalną tulejkę w motocyklu CRF250L. Musiałem szybko zamówić nową ta tulejka pasuje i wygląda jak oryginał. Po jeździe testowej w terenie dalej działa. Polecam

Reliable opinion

2024-01-22, 17:20

View original

Andrzej

Well matched to Nissin brake discs, work well with them, show long service life. Recommended.

Reliable opinion

2024-11-07, 08:28

View original

Furui

Geliefert wie bestellt. Alles in Ordnung. Ich würde wieder bei GMoto bestellen. Es ist ein verlässlicher Lieferant.

Reliable opinion