Motorcycle brakes
Honda GB 500 Clubman 1990

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Reliable opinion

2024-05-12, 05:01

View original

Piotr

Everything fits . Parts of good quality . Lack of grease in the kit which is in the picture, for me acutely lack of grease not very important because I have a large tube because I am always missing. Anyway it fits and I recommend. The clamp works well and does not leak.

Reliable opinion

2022-01-23, 22:26

View original

Michał

The piston fits the caliper perfectly. It is dimensional, consistent with the original. Used in older nissin calipers.

Reliable opinion

2024-05-12, 04:57

View original

Piotr

Everything fits. The pads brake very well recommend. Product quality very good at a good price.

Reliable opinion