Motorcycle brakes
Honda VFR 400 R 1986

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2019-12-27, 13:32

View original

Mariusz

Honda Shadow VT 600 1994. The kit includes all the gaskets that need to be replaced when reconditioning the brake caliper, plus grease for the piston. Everything fit as in the original.

Review translated automatically

Reliable opinion

2020-10-26, 17:04

View original

Mariusz

Honda Shadow 1100 ACE 1996, Front brake repair kit identical to the original, when assembled everything fits perfectly.

Review translated automatically

Reliable opinion