Motorcycle brakes
Honda XL 650 Transalp - Page 2

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2024-05-02, 17:02

View original

xxx

I am really satisfied with the purchased bolt. It is well made and meets my expectations, it is a good choice, I will definitely order something again and more than once.

Review translated automatically

Reliable opinion

2024-08-25, 12:26

View original

Dawid

Pads are ok for a long time, brakes very well, price to quality ratio very positive

Review translated automatically

Reliable opinion

2024-02-29, 08:19

View original

Jakub

Good quality I've been driving for 2 years now and the lining has shrunk by only about 4mm whether mud or dirt they brake perfectly I recommend

Review translated automatically

Reliable opinion