Motorcycle brakes
Honda XLV 750 R 1983

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2023-05-19, 05:35

View original

Jeremiasz

Very nice workmanship with good strong material fits the caliper perfectly works well on KTM SX 125

Review translated automatically

Reliable opinion

2024-06-08, 22:37

View original

Kacper

Everything fits as expected, good quality product, there was no problem with the fit and installation.

Review translated automatically

Reliable opinion

2022-05-29, 20:11

View original

Jacek

Honda Varadero 125, a part worth recommending, fits, workmanship good, everything works as expected.

Review translated automatically

Reliable opinion

2024-05-12, 04:57

View original

Piotr

Everything fits. The pads brake very well recommend. Product quality very good at a good price.

Review translated automatically

Reliable opinion