Motorcycle brakes
Kawasaki ZX-12R 1200 Ninja - Page 2

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Reliable opinion

2024-11-24, 22:30

View original

Javier

Solo incluye las piezas internas de cilindro. Falta el reten del tubo del deposito y tambien el guardapolvos del actuador externo.

Reliable opinion

2024-11-07, 08:28

View original

Furui

Geliefert wie bestellt. Alles in Ordnung. Ich würde wieder bei GMoto bestellen. Es ist ein verlässlicher Lieferant.

Reliable opinion