Motorcycle brakes
Suzuki GSF 1200 Bandit - Page 4

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2017-05-15, 21:39

View original

Wiesław

Suzuki GSX-R 1100 motorcycle from 1987 . Due to its age I decided to replace the front master cylinder , searching through the offers I came across a repair kit at gmoto.pl and decided to purchase it along with the brake lever that works with the piston and may have been worn out . The parts after unpacking turned out to be not different in appearance and quality from the original with the included box of special grease . With the assembly there was no problem . All parts fit and work as intended .

Review translated automatically

Reliable opinion

2017-11-04, 10:28

View original

Patryk

I own a 2003 Suzuki DL 1000 motorcycle. Reperature of the front brake master cylinder I needed because it began to leak and go hard. The replacement is not difficult and the parts fit well. Even without instructions there are no problems to assemble everything correctly ;)

Review translated automatically

Reliable opinion

2020-08-08, 13:12

View original

Rajmund

The motorcycle is a honda transalp 600 1996r.The element fit perfectly without any reservations thanks to good workmanship and fit the repair went quickly and efficiently.Regards

Review translated automatically

Reliable opinion

2018-05-26, 07:30

View original

Piotr

I installed in suzuki hayabusa, parts fit well, high quality workmanship, the kit contains all the components for a comprehensive repair of the pump

Review translated automatically

Reliable opinion

2023-10-24, 06:02

View original

Patryk

Cables of the highest quality, very aesthetically made, very good fit, + for the additional cable holders.

Review translated automatically

Reliable opinion

2023-06-16, 06:50

View original

Marcin

Very good replacement quality materials exceed the original. I bought both the clutch pump and the brake master cylinder. I recommend

Review translated automatically

Reliable opinion

2024-05-11, 08:00

View original

Maksym

The shield fits perfectly, does not heat up, you can see that it is made solidly ! I highly recommend this product !

Review translated automatically

Reliable opinion

2021-05-03, 07:23

View original

Arkadiusz

Suzuki GSXR 1100 year 1995.Kit fits everything ok,fast shipping overseas. I recommend the seller.

Review translated automatically

Reliable opinion

2021-03-13, 08:30

View original

Krzysztof

Suzuki DL 1000 02r. Very good quality at an affordable price. Excellent fit. I recommend 100%.

Review translated automatically

Reliable opinion