Motorcycle brakes
Suzuki XF 650 Freewind - Page 2

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2020-03-29, 13:48

View original

JACEK

The brake caliper repair kit I ordered fits my Drifter perfectly. The cylinder seals fit well and the quality of the rubber and workmanship looks correct. The included grease in the kit is in sufficient quantity. I recommend this kit for its low price and good quality.

Review translated automatically

Reliable opinion

2020-08-08, 13:12

View original

Rajmund

The motorcycle is a honda transalp 600 1996r.The element fit perfectly without any reservations thanks to good workmanship and fit the repair went quickly and efficiently.Regards

Review translated automatically

Reliable opinion

2024-08-25, 12:26

View original

Dawid

Pads are ok for a long time, brakes very well, price to quality ratio very positive

Review translated automatically

Reliable opinion

2024-09-29, 17:35

View original

Sebastian

Suzuki VZ 800 - The pads fit perfectly. Replaced at the beginning of the season. During operation zero objections.

Review translated automatically

Reliable opinion