Motorcycle brakes
Yamaha FZS 1000 Fazer - Page 2

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2018-05-16, 23:39

View original

Damian

I own a 2002 Yamaha Fzs 1000 Fazer. I purchased steel braided brake lines from HEL. The quality of the lines is great, they look great. I had to do a bit of fiddling to fit them to my Jadzia, but the end result is most satisfactory. The brakes go like razor blades. Brake stroke much smaller, per finger. Everything according to the plan :)

Review translated automatically

Reliable opinion

2024-10-19, 17:03

View original

Adrian

The erasers fit the 2015 Tenera 1200 perfectly. However, the set includes 4 copper washers, and we need 5 of them.

Review translated automatically

Reliable opinion

2018-02-17, 19:19

View original

Maciej

Sealers really well made , fit very well . The installation went smoothly and quickly

Review translated automatically

Reliable opinion