Motorcycle brakes
Yamaha FZS 600 Fazer - Page 2

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2018-04-16, 07:54

View original

Łukasz

Wires fitted perfectly to the motorcycle. Riding comfort definitely on the plus side. They improve the appearance of the moto. Recommended.

Review translated automatically

Reliable opinion

2024-06-06, 11:29

View original

Łukasz

Very good quality and super performance. Brake efficiency is sky better. I recommend the purchase and replacement to everyone.

Review translated automatically

Reliable opinion

2018-02-17, 19:19

View original

Maciej

Sealers really well made , fit very well . The installation went smoothly and quickly

Review translated automatically

Reliable opinion