Transmission crankcase bushings

2024-09-26, 18:09

View original

Tomasz

Czesc, zakupiłem tulejkę do wsk 125 b3 73r jeżeli dobrze pamiętam rocznik. Jeżeli chodzi o wymiar zewnętrzny jest poprawy, natomiast długość trzeba dopasowywać szlifując ją na papierze ściętym do silnika. Ponieważ niekiedy po skręceniu silnika skrzynia stoi dęba. Wszystko zależy od stanu zużycia naszego silnika. Moja musiałem podszlifować 0,5mm aby skrzynia obracała się lekko. Brąz bardzo twardy i odporny na zużycie polecam

Reliable opinion

2024-11-04, 17:28

View original

Kacper

Tragedy don't put this in your engines at my Jawa did about 10mth and started howling it turned out that the bushing had worn out all the way to the crankcase. Don't want to know what could have happened.

Reliable opinion

2024-10-28, 02:35

View original

Patryk

The sleeve is made of such material as stated in the description. The dimensions are consistent. The workmanship performed at a b.good level. Good price, recommend.

Reliable opinion

2023-07-01, 08:55

View original

Bernard

The bushings should be bronze and they are brass, Bronze is hard to find. It would be better if the distribution is from a Polish manufacturer.

Reliable opinion

2022-02-13, 18:53

View original

Dariusz

The bushing went in without a problem after heating the crankcase, but it was too shallowly drilled about 3 mm and not countersunk straight with the boring bar, which made it impossible to assemble the engine. Linden from under the drill

Reliable opinion