S&S Cycle - Crankshafts

2024-06-04, 21:37

View original

Oskar

The product does not fit the d50b0 engine, it is designed for ebs engines, which was not mentioned anywhere. In the list of motorcycles to which this crankshaft fits were listed models with d50b0 engine, which misleads people. In this list you could also find my motorcycle model derbi senda drd racing 2007, so I bought this product, but only after assembling the engine with this shaft I realized that it is too long and the crankcase covering the clutch does not fit. The shaft is adapted for the ebs engine in which there are 2 cogs superimposed on the shaft, while in the d50b0 there is only 1 cog and a free space is left between the cog and the nut

Reliable opinion

2024-01-20, 13:34

View original

Henryk

The shaft was precisely made. There were no problems with assembly. Unfortunately, with materials of not the best quality. 1. during operation, the plastic gear of the speed controller broke and damaged the drive gears of the balance shaft and camshaft. a piece of plastic should not damage the steel gear. 2. the keyway and journal channel on which the flywheel is seated was damaged. Even if the flywheel came loose for some reason during operation, the keyway should be cut and the journal should remain undamaged. Either the material was too soft, or the heat treatment was improper.

Reliable opinion

2024-05-03, 10:16

View original

Jacek

The shaft very fit. I even expected that the piston pin bearing would fly loose, and here, slowly and carefully had to be assembled so as not to damage the bearing. This is very much on the plus side! Because a good fit is important here! Is the shaft itself in itself durable? It's hard to say, currently Ogar 200 has already done a good 1,500 kilometers on this shaft with SKF pin bearing and laughs on! :)

Reliable opinion

2024-09-30, 19:46

View original

Damian

Quick easy and specific! very easy to order site very convenient I ordered a shaft which turns out to be very good and of good quality everything as expected I recommend this shaft for minarelli engines under 70 airsala lux

Reliable opinion

2024-07-22, 05:17

View original

wiktor

The crankshaft turned out to be well stocked with good materials durable in the kit are not unnecessary components such as needle bearing fits d50b0/1 engines I could recommend this product to anyone

Reliable opinion