Electrical installations - motorcycle wiring harnesses
MZ ETZ 150

2018-02-12, 21:43

View original

Andrzej

MZ ETZ 125 90" installation quality ok lengths of wires well matched plus heat shrink shirts on all connectors. Schematics clear and understandable but with an error. The mistake was that the turn signal light was connected to two wires in one pin, but they should have been separated into two separate pins to plug into two poles of the light otherwise we would have four lights at once. In addition, it would be useful to have a description that the rear lamp is controlled by a minus and will not work properly for us if we have a lamp with a dual-filament bulb because the position lights require constant ground. After the corrections, the installation works flawlessly.

Review translated automatically

Reliable opinion

2016-03-13, 08:24

View original

Krzysztof

Mz Etz 150 1991r. Very good workmanship, all terminals, connectors perfectly matched so there is no question of them falling out of their intended place (pins). The length of the cables very well matched and the enclosed manual makes it very easy to install even for a layman because it is clear.

Review translated automatically

Reliable opinion