Forgot password
Order status
Free delivery from 150 euro
Harness - electrical installation MZ ETZ 150 250 251 - 85342
€59.15 including VAT
We keep up with your passion!
Delivery tailored to your needs
You have 15 days to make a decision
New electrical installation for MZ ETZ 125 150 and 250 motorcycles
| Manufacturer: | W55 |
|---|---|
| Manufacturer id: | 85342 |
- harness made in Poland from the highest quality materials, which ensures reliability and long life
- all wires on the diagrams are marked in color so that the installation to the motorcycle is not complicated
Attention!!!
In most cases, you buy the installation without the harness that powers the indicator lights in the clocks. In this case, all the wires are included.
The harness comes with three detailed diagrams:
1. a schematic diagram,
2. diagram of individual harnesses with a description of the end of each cable part 1,
3. diagram of individual bundles and individual wires with a description of the end of each cable part 2.
Gmoto.pl Paweł Cebulak, Tadeusza Kościuszki 78, 37-100, Łańcut, PL, [email protected]
Fits to
- MZ ETZ 125 Saxon Roadstar 1992
- MZ ETZ 125 Saxon Roadstar 1994
- MZ ETZ 125 Saxon Sportstar 1992
- MZ ETZ 125 Saxon Sportstar 1994
- MZ ETZ 125 Saxon Sportstar 1995
- MZ ETZ 125 Saxon Sportstar 1996
- MZ ETZ 125 hamulec tarczowy 1985
Product reviews
5
4
3
2
1
-
Elégedett vagyok a rendeléssel. A terméket gyorsan megkaptam. A mellékelt használati utasítással azt gondolom könnyen fel tudom majd használni.
Review translated automatically
Reliable opinion
-
-
All cables fit perfectly, very accurate description on the sheet attached to the bundle, product I recommend in good conscience
Review translated automatically
Reliable opinion
-
-
MZ ETZ 150 excellent quality product everything readable,diagrams brilliant make work very easy.More such products.
Review translated automatically
Reliable opinion
-
-
MZ ETZ 125 90" installation quality ok lengths of wires well matched plus heat shrink shirts on all connectors. Schematics clear and understandable but with an error. The mistake was that the turn signal light was connected to two wires in one pin, but they should have been separated into two separate pins to plug into two poles of the light otherwise we would have four lights at once. In addition, it would be useful to have a description that the rear lamp is controlled by a minus and will not work properly for us if we have a lamp with a dual-filament bulb because the position lights require constant ground. After the corrections, the installation works flawlessly.
Review translated automatically
Reliable opinion
-
-
Mzecia 150 etzecia very good quality workmanship everything fits nicely and most importantly works flawlessly rating 5+
Review translated automatically
Reliable opinion
-
-
Good installation. Well made. Too bad the cable colors are not the same as the original. I recommend.
Review translated automatically
Reliable opinion
-
-
Etz 150'1989
Review translated automatically
Reliable opinion
-
-
Mz Etz 150 1991r. Very good workmanship, all terminals, connectors perfectly matched so there is no question of them falling out of their intended place (pins). The length of the cables very well matched and the enclosed manual makes it very easy to install even for a layman because it is clear.
Review translated automatically
Reliable opinion
-
-
mz etz 251, quality of workmanship excellent to this clear diagrams
Review translated automatically
Reliable opinion
-
-
Mz ETZ 150 1989r Very good product
Review translated automatically
Reliable opinion
-
-
MZ ETZ
Review translated automatically
Reliable opinion
-
-
Review translated automatically
Reliable opinion
-
Questions & Answers
Have a question about this product?
No one has asked a question about this product yet. Be the first and get an answer from our community or experts!
