Forgot password
Order status
Free delivery from 150 euro
Fuel tank petcocks repair kits
Romet Komar 50
Price
Sort
Products reviews
Warm greetings. Junak M10 from 1965. the gasket fit the faucet well, thickness good, after installation does not leak, works properly. I recommend and greetings.
Review translated automatically
Reliable opinion
Greetings. WSK B1 from 1969.The gasket is thick I could barely close the faucet but yes also it must be tight and tight. Greetings and recommend. Krzysztof
Review translated automatically
Reliable opinion
WSK 175 S2 SPORT Gasket made of very good quality material reflecting perfectly the original fits in the faucet like a glove highly recommend
Review translated automatically
Reliable opinion
Wsk m06-z2. The rubber used to make the faucet gasket is not resistant to fuel. It swelled and flew apart after just a few minutes.
Review translated automatically
Reliable opinion
Unfortunately, the quality of the rubber from which the gasket was made fatal. In fact, it is unusable after literally several uses of the faucet.
Review translated automatically
Reliable opinion
I needed the present gasket for the faucet mounted in the tank of a small soiler. I could not find it anywhere. Only on your site, in addition to a photo of the gasket and information that it fits a Junak, its dimension was given - a diameter of 17 mm. This decided me to make the purchase. The gasket fits and is OK. A small thing but very happy. It is often the case that you buy things that you need to adapt for your own needs, and then such information is essential.
Review translated automatically
Reliable opinion
Hello, I own a SHL Gazelle motorcycle with a capacity of 175 ccm. The fuel faucet gasket I purchased fits well and has an aesthetic appearance. About the material from which it is made I can not say too much because it was recently put on. So far it is fulfilling its purpose. Regards.
Review translated automatically
Reliable opinion
Romet Kadet. Before installing the gasket, I recommend sanding the surface of the faucet knob to get rid of pitting, because whatever the gasket is, fuel will escape through the pitting. If someone does not have mechanical sense, I recommend buying a complete faucet, which is a few zlotys more expensive.
Review translated automatically
Reliable opinion
The supplier showed professionalism regarding the preparation AND delivery of the shipment of parts for Junak M10. I was very impressed by the electronic notification system of the status of the order until delivery to the addressee. Very fast delivery and without courier.
Review translated automatically
Reliable opinion
A small thing, and it allows you to resuscitate a leaking fuel faucet. Thus, the fuel does not escape uncontrollably. The very good quality of the gasket will probably allow for long use. So you can enjoy using your Komar and drive it happily for more kilometers
Review translated automatically
Reliable opinion
For the mosquito faucet 2350 fits and seals well (despite the lack of one hole for a spline to prevent displacement). The faucet moves much harder than with a cork gasket (which may be a disadvantage for some for others an advantage)
Review translated automatically
Reliable opinion
The gasket is a bit too big. It seems to fit, but when you press it in it can get damaged. I sanded it down with sandpaper a little on each side until it fits perfectly and now nothing leaks, it seals very well.
Review translated automatically
Reliable opinion
Hello, I own two 1985 M-2 motorcycles and one 1987 M-3. I am currently in the process of rebuilding each in turn. The parts I bought from Gmoto met my expectations. They were of good quality and fit without any problems.
Review translated automatically
Reliable opinion
I purchased an o-ring for the faucet from an ogar 205. Unfortunately, it turned out that the o-ring is quite a bit too big and despite using force, I was not able to tighten the lower part of the faucet all the way. Fortunately, it is quite tight and nothing is leaking.
Review translated automatically
Reliable opinion
I have a moped Komar r.p.1984 quite badly damaged inherited by my father(1 owner) with the original and manual and proof of purchase.It required a small renovation renewal of the paint and fill in the gaps in the equipment.
Review translated automatically
Reliable opinion
Everything works well with the faucet previously purchased at www.gmoto.pl for only 9,99 zloty. The only drawback is that in the picture there is a bark tree gasket, and I received a rubber one. However, it works well.
Review translated automatically
Reliable opinion
I'm just thrilled with this gasket because I finally ended the problems with the faucet leaking outside and also when you take the hose off the carburetor it finally doesn't leak from the hose when it's closed.
Review translated automatically
Reliable opinion
Romet Motorynka 1980 Motorynka undergoes a major overhaul, I replace all components that are damaged or tired of time :). Good quality goods. Was it worth buying - definitely YES
Review translated automatically
Reliable opinion