Forgot password
Order status
Free delivery from 150 euro
Motorcycle brake calipers
Honda CB 1100 R 1982
Options +1 
Browse by manufacturer
Products reviews
I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.
Review translated automatically
Reliable opinion
Yamaha DT125. When replacing the brake fluid, it turned out that my caps were scarred and not suitable for re-installation. I regretted that when I bought the fluid I did not order the caps right away, because they cost pennies, and ordering separately more expensive would be the shipping alone. Therefore, I recommend if you only have doubts about your hoods. They are flexible, they probably fit all diameters of vent valves, the extra eyelet guarantees that you will not lose them.
Review translated automatically
Reliable opinion
Good morning, I was looking everywhere for this particular replacement, but I only found it in this store. I am very happy with the quality of the product in relation to the price. It's worth it and more.
Review translated automatically
Reliable opinion
Yamaha YZF R1 2004 and Honda quad 250, caps made solidly for sure will not tear, fit perfectly into the air vent nothing stands out - they are not too loose. If anyone has this model of Yamaha or quad I recommend it
Review translated automatically
Reliable opinion
Excellent product. It fit properly in the caliper and I no longer have any leakage from the wear and tear of the previous one. Tourmax quality comparable to the factory ones.
Review translated automatically
Reliable opinion
Good product delivered quickly. I searched for a while to avoid spending so much and found what I was looking for at GMOTO. That's how it should be.
Review translated automatically
Reliable opinion
Delivered as ordered. Everything in order. I would order from GMoto again. It is a reliable supplier.
Review translated automatically
Reliable opinion
Recommended. 100% satisfaction. Full compatibility. Fast delivery, seamless transaction. Thank you and best regards.
Review translated automatically
Reliable opinion
Otherwise good, but 5mm longer than the original 1984 Honda CB400N pin. However, it didn't interfere with the installation.
Review translated automatically
Reliable opinion
The piston fits the caliper perfectly. It is dimensional, consistent with the original. Used in older nissin calipers.
Review translated automatically
Reliable opinion
Simple processing, fast delivery, item meets expectations, good price-performance ratio
Review translated automatically
Reliable opinion
Honda Varadero 125, parts fit, everything works as expected after installation, quality of goods good.
Review translated automatically
Reliable opinion
perfect 1st order on this site to put in your favorites I recommend .
Review translated automatically
Reliable opinion