Motorcycle brakes
BMW R 1200 RT 2012 - Page 2

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2025-04-13, 11:27

View original

NIKOS

Excellent product. It fit properly in the caliper and I no longer have any leakage from the wear and tear of the previous one. Tourmax quality comparable to the factory ones.

Review translated automatically

Reliable opinion

2025-07-27, 08:46

View original

Eckehard

Good product delivered quickly. I searched for a while to avoid spending so much and found what I was looking for at GMOTO. That's how it should be.

Review translated automatically

Reliable opinion

2024-11-07, 08:28

View original

Furui

Delivered as ordered. Everything in order. I would order from GMoto again. It is a reliable supplier.

Review translated automatically

Reliable opinion