Motorcycle brakes
BMW R 1200 ST ABS 2008

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2019-03-26, 07:34

View original

Piotr

I own a motorcycle BMW R1150RT Year 2001 old but spring more comfortable I have not had. Bought the pin holding the pads fits perfectly and is protected from corrosion. In a word, the original there is nothing to attach to.

Review translated automatically

Reliable opinion

2020-07-22, 14:23

View original

Kamil

Good quality metal and rubber. Fits perfectly instead of old rusty vents. Highly recommended.

Review translated automatically

Reliable opinion

2026-01-28, 08:15

View original

Antonio

Hello at the moment I have not had the opportunity to use the funnel as the repair is in progress waiting for other parts but I know the product as I have worked for bmw and is exactly the same so I can say that performs its function to perfection proof of this are these two photos that I upload here so that everyone who is thinking of buying one can do so with complete confidence that it is perfect, thank Gmoto service and speed of delivery everything was very simple. Thank you very much and a greeting to all the Gmoto team.

Review translated automatically

Reliable opinion

2025-08-28, 19:21

View original

Jochen

Unfortunately, the seal on the lower thread was not big enough and the brake fluid leaked out at the screw connection. I was able to help myself and use another seal from my spare parts shelf and then everything was OK

Review translated automatically

Reliable opinion

2024-09-16, 20:05

View original

Patrik

Unfortunately, the connection of the reservoir is not tight, which means you end up with more mess than if you pour the brake fluid over it by hand. You can no longer stop when the reservoir is full and sitting on the ABS block. Really very disappointing.

Review translated automatically

Reliable opinion

2025-03-24, 19:39

View original

Tobias

The filler did its job well, the thread fitted and also held tight, contrary to expectations, as some YouTube tutorials had spoken of leaks. However, the price is quite high for such a simple part.

Review translated automatically

Reliable opinion

2025-05-01, 15:25

View original

Heinrich

The part cannot be used for the BMW R1150 GS with Integral ABS because it does not seal at the reservoir. The brake fluid runs out heavily at the screw-in thread. Screwing it in tighter would damage the thread.

Review translated automatically

Reliable opinion

2025-04-13, 11:27

View original

NIKOS

Excellent product. It fit properly in the caliper and I no longer have any leakage from the wear and tear of the previous one. Tourmax quality comparable to the factory ones.

Review translated automatically

Reliable opinion

2025-07-27, 08:46

View original

Eckehard

Good product delivered quickly. I searched for a while to avoid spending so much and found what I was looking for at GMOTO. That's how it should be.

Review translated automatically

Reliable opinion

2024-11-07, 08:28

View original

Furui

Delivered as ordered. Everything in order. I would order from GMoto again. It is a reliable supplier.

Review translated automatically

Reliable opinion