Motorcycle brakes
Honda CB 1000 RA ABS 2009

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2020-06-15, 13:16

View original

Wojciech

I own a 2006 Honda Deauville 700 motorcycle. I called the store to inquire about brake pads and the salesman convinced me to buy pads from a different company than I had originally planned to buy. In a professional manner, he convinced me to change my decision, convincing me of the better quality of the product, at a better price and the fact that he himself uses pads from this brand. After driving nearly a thousand kilometers, I can say with a clear conscience that it was a very good decision, the product perfectly meets my requirements, and the store itself and its sellers I will certainly take into account in the next purchases of parts for my moto.

Review translated automatically

Reliable opinion

2018-08-16, 09:50

View original

Michał

Yamaha DT125. When replacing the brake fluid, it turned out that my caps were scarred and not suitable for re-installation. I regretted that when I bought the fluid I did not order the caps right away, because they cost pennies, and ordering separately more expensive would be the shipping alone. Therefore, I recommend if you only have doubts about your hoods. They are flexible, they probably fit all diameters of vent valves, the extra eyelet guarantees that you will not lose them.

Review translated automatically

Reliable opinion

2024-09-20, 06:29

View original

Alexandros

Good morning, I was looking everywhere for this particular replacement, but I only found it in this store. I am very happy with the quality of the product in relation to the price. It's worth it and more.

Review translated automatically

Reliable opinion

2024-09-20, 06:31

View original

Alexandros

Good morning, I was looking everywhere for this particular replacement, but I only found it in this store. I am very happy with the quality of the product in relation to the price. It's worth it and more.

Review translated automatically

Reliable opinion

2018-01-08, 08:41

View original

Marcin

Yamaha YZF R1 2004 and Honda quad 250, caps made solidly for sure will not tear, fit perfectly into the air vent nothing stands out - they are not too loose. If anyone has this model of Yamaha or quad I recommend it

Review translated automatically

Reliable opinion

2020-08-07, 08:12

View original

Sergii

Fits 2016 Honda VFR800X Crossruner on the rear axle, installation without any problems. The pads need some time to start braking properly on the motorcycle. They have fewer ventilation channels than the original.

Review translated automatically

Reliable opinion

2024-09-20, 09:22

View original

Ralph

Beautiful orange colored hose clamp, unfortunately the rubber in the inner part is very large to the clamp so that you see little of her.better use a smaller rubber then she looks very good

Review translated automatically

Reliable opinion

2025-08-14, 08:29

View original

Mario

Good product that is already in use! I can only recommend it. Well described, which often leads to incorrect orders in other stores because the descriptions are not good or complicated.

Review translated automatically

Reliable opinion

2025-04-13, 11:27

View original

NIKOS

Excellent product. It fit properly in the caliper and I no longer have any leakage from the wear and tear of the previous one. Tourmax quality comparable to the factory ones.

Review translated automatically

Reliable opinion

2025-07-27, 08:46

View original

Eckehard

Good product delivered quickly. I searched for a while to avoid spending so much and found what I was looking for at GMOTO. That's how it should be.

Review translated automatically

Reliable opinion

2024-11-07, 08:28

View original

Furui

Delivered as ordered. Everything in order. I would order from GMoto again. It is a reliable supplier.

Review translated automatically

Reliable opinion

2021-04-09, 17:18

View original

Piotr

Recommended. 100% satisfaction. Full compatibility. Fast delivery, seamless transaction. Thank you and best regards.

Review translated automatically

Reliable opinion

2023-05-19, 05:35

View original

Jeremiasz

Very nice workmanship with good strong material fits the caliper perfectly works well on KTM SX 125

Review translated automatically

Reliable opinion

2024-06-08, 22:37

View original

Kacper

Everything fits as expected, good quality product, there was no problem with the fit and installation.

Review translated automatically

Reliable opinion

2022-05-29, 20:11

View original

Jacek

Honda Varadero 125, a part worth recommending, fits, workmanship good, everything works as expected.

Review translated automatically

Reliable opinion

2022-05-29, 20:10

View original

Jacek

Honda Varadero 125, parts fit, everything works as expected after installation, quality of goods good.

Review translated automatically

Reliable opinion