Motorcycle brakes
Kymco Yager/Spacer 50 2T 2002

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2020-04-29, 18:32

View original

Adam

I have a Honda CRF 100, I bought the brake shoes and the whole drive.Everything packed perfectly nothing inside moves freely ,they do not save on bubble wrap

Review translated automatically

Reliable opinion

2023-01-06, 15:07

View original

Rex

KYMCO GRAND DINK 125 2005. Brake pads purchased from Gmoto store met my expectations, very good workmanship and affordable price. The dimensions of the pads perfect as factory. The old brake pads, although they were not heavily worn over time, became hard and began to form scratches on the brake discs you had to use a lot of force to brake. After installing new pads, the braking distance was reduced by more than half. The discs no longer heat up, and I regained full control of my motorcycle. Thanks to Gmoto, the scooter runs, honks, brakes and works every day.

Review translated automatically

Reliable opinion

2024-05-03, 03:48

View original

Piotr

The only brake caliper that fits the 2011 Kreidler DD supermoto, even though it is not in the description it fits just measure the mounting distance between the pins. At last I have decent brakes. I recommend.

Review translated automatically

Reliable opinion

2025-09-22, 05:13

View original

Sebastian

Good replacement for a worn drum brake, in my case on the Speedfight 2. Installation in under 5 minutes, without any special tools. Now the rear brake finally works as it should.

Review translated automatically

Reliable opinion

2020-08-08, 13:12

View original

Rajmund

The motorcycle is a honda transalp 600 1996r.The element fit perfectly without any reservations thanks to good workmanship and fit the repair went quickly and efficiently.Regards

Review translated automatically

Reliable opinion

2025-04-13, 11:27

View original

NIKOS

Excellent product. It fit properly in the caliper and I no longer have any leakage from the wear and tear of the previous one. Tourmax quality comparable to the factory ones.

Review translated automatically

Reliable opinion

2025-07-27, 08:46

View original

Eckehard

Good product delivered quickly. I searched for a while to avoid spending so much and found what I was looking for at GMOTO. That's how it should be.

Review translated automatically

Reliable opinion

2024-11-07, 08:28

View original

Furui

Delivered as ordered. Everything in order. I would order from GMoto again. It is a reliable supplier.

Review translated automatically

Reliable opinion

2019-08-18, 08:25

View original

Marian

Brake shoes from the appearance very nice. I will be able to judge the quality during operation and after the service period.

Review translated automatically

Reliable opinion

2024-10-11, 14:16

View original

Michael

Fits exactly for the brake calipers of Kymco Like 125 or Kymco Like 50, quality is quite good, gladly again.

Review translated automatically

Reliable opinion