Motorcycle carburettor components
Malaguti F10 25 Jetline 1997

2024-12-27, 18:42

View original

IOANNIS MAKRIS

I have attached a photo of the factory reed next to the reed I installed.There is a difference in the size of the intake so that more air enters and I have more compression.With the first start the difference was immediately apparent having a 17.5mm carburetor.When I put 21mm it will be even better. The compression is higher and it works very fast.

Review translated automatically

Reliable opinion

2020-05-18, 17:14

View original

Adrian

Benelli 491 98r Valve in working order without any defects or sharp edges Construction is polished hard plastic, contact surfaces are elegantly sanded evenly, plates are quite hard I think this will prolong the life and at the same time strengthen the machine.

Review translated automatically

Reliable opinion

2019-08-31, 16:03

View original

STEFAN

Hello,the goods fit perfectly,everything fits like from the factory thanks to this I did not have to buy a new gasser,after putting on the set the gasser came to life and works sensationally. Thank you and best regards.

Review translated automatically

Reliable opinion

2020-05-31, 11:43

View original

Paweł

Suzuki AP50 97. EVERYTHING as described. I HAD TO REDO THE BASE BECAUSE THE CARBURETOR WAS SET IN A DIFFERENT DIRECTION THAN ON THE ORIGINAL BUT I RECKONED WITH IT. NOW THE SCOOTER HAS MORE POWER.

Review translated automatically

Reliable opinion

2023-06-20, 18:36

View original

Darek

Diameter 3.7mm, length ~10.7mm (with cape pressed on top). Unfortunately it doesn't fit my motorcycle, bought by eye according to the photo, which doesn't say anything about the size.

Review translated automatically

Reliable opinion

2020-07-27, 20:32

View original

Kamil

everything ok I recommend the kit fits the gasser I recommend the seller and I will definitely use the services but not the shipments through the polish post office

Review translated automatically

Reliable opinion