Motorcycle clutch - Page 168

2020-02-25, 22:48

View original

Johan

For my Hondas FT 500 (1983) & XBR 500 (1986) as spares. Remove the lever first, then punch out the old one from the contact pins side; it's an easy, light press fit. When pressing in the new one, align the hook on the switch with the notch in the clutch lever body. Note the hole in the switch also lines up with a hole at the underside of the alu body; it's for contact spray when needed. (Better use it before needed; once corroded the inner contact becomes difficult).

Review translated automatically

Reliable opinion

2024-03-04, 06:42

View original

Łukasz

Affairs, it conducts electricity. However, it does not fit the 1976 GL1000 K1 model, as it has a larger diameter than the original (factory) and will not go into the hole in the handle holder. I had to take the original one apart despite the damage and was able to repair it. Perhaps this one will fit the specified GL1000 78-79 but I will check this when I give it to a colleague. It would be good to have the basic dimensions plotted on the parts in the photo to see if it will fit us.

Review translated automatically

Reliable opinion

2019-08-24, 05:46

View original

Rafał

Hi . I recommend this product very warmly , the quality and price is very satisfactory . Very fast shipping , and the courier package itself well protected against damage to the product . Best regards Rafal

Review translated automatically

Reliable opinion

2022-01-16, 18:05

View original

Krzysztof

Yamaha Midnight Star XVS 1300 vintage 2013 Although it's a replacement it fit perfectly in place of the damaged original. It works flawlessly and considering the price .compared to the original it compares very well .

Review translated automatically

Reliable opinion

2024-01-27, 19:20

View original

Tomasz

The clutch cover gasket, in my opinion, does its job 100 percent. If the need arises to buy a gasket again for another motorcycle, the choice will be obvious.

Review translated automatically

Reliable opinion

2022-01-17, 09:53

View original

Łukasz

The product as good as possible. Bought for the 2nd time (Unfortunately, there was a need to remove the clutch). Fits perfectly into the engine marked 4BR in Yamaha XJ600N from 98r.

Review translated automatically

Reliable opinion

2024-05-27, 08:30

View original

Tomasz

Gasket ok visually. I did not install because the original one survived the disassembly without the slightest damage and is tight after reassembly.

Review translated automatically

Reliable opinion

2025-07-06, 09:07

View original

Robert

Fits very well. Does what it is supposed to do. As always, the quality only becomes apparent over a longer period of time. So wait and see.

Review translated automatically

Reliable opinion

2018-04-10, 13:00

View original

Marek

Product of very good quality, duly made, fits perfectly in place of the old one and fulfills its purpose 100%.

Review translated automatically

Reliable opinion

2020-11-07, 21:24

View original

Robert

Yamaha xvz12TD. Everything fits seamlessly. Thank you. I will definitely come back to you guys.

Review translated automatically

Reliable opinion

2016-06-22, 21:36

View original

Bartłomiej

Yamaha xj 600 year 1998 , I recommend very good quality at a low price

Review translated automatically

Reliable opinion

2016-02-15, 10:44

View original

Krzysztof

yamaha drag star 650.Ordered part very good quality.I recommend

Review translated automatically

Reliable opinion