Forgot password
Order status
Free delivery from 150 euro
Motorcycle electrical & lighting
Honda CBR 600 F F2 1991
Browse by manufacturer
Products reviews
Everything ok, I recommend for CB500 - fits perfectly. The heat sink provides adequate cooling, the factory one did not have it and there was a problem.
Review translated automatically
Reliable opinion
About a year ago I installed a colleague in a Honda CB500 - probably 1998.To this day he does not complain. Recently another colleague had a charging problem (also CB500, 1999) and asked for advice (the previous regulator - "more branded", read much more expensive - seemed to overcharge the battery [colleague's opinion, I did not check]. It turned out that everything was OK, the one evaluated remained stock). In both cases, the spacing of the mounting holes did not fit very well, but it's 0.6 mm max - just "lick" the housing with a suitable conifer. There could be a little more charging voltage (original :14.5 V, evaluated : 14.17 and 14, 22 V - two copies). If someone "embraces currents" and would like to check the reg. "dry", just like the "classic" ones. - regulated power supply, bulb voltmeter - then you may be strongly surprised. But after installation in the motorcycle everything OK. Probably some "more advanced" technology (perhaps - it's a little undervoltage is also not always so ?) Considering the price / quality ratio - I recommend. In general - in Hondas (at least of these vintages) you need to take care of the charging installation. Most often the problems begin at the connectors of the 3 yellow cables from the alternator. Corrosion, oxidation, increase in resistance, overheating, the rectifier-regulator begins to overheat, the internal electronics fall apart, no longer regulate the voltage and we have a "bubble" from the battery. It is worth checking these areas carefully. With Hondas (CB500, Transalp) I have done a little more than 80 kkm, and also a little at colleagues' repair.
Review translated automatically
Reliable opinion
Honda CB 500 S, 1999. Before replacement charging only above 3000 rpm at slow 12.3 volts without load, after replacement 14.3 volts after load 14.1-14 volts (you would have to check the battery and the pradnic-alternator itself before you proceed with the replacement) In summary - good purchase quality / price I recommend
Review translated automatically
Reliable opinion
After ordering the product, I did not expect to get it earlier than it was described, I got the product 1 earlier than the scheduled delivery, the product well protected in the shipment, it works flawlessly :)
Review translated automatically
Reliable opinion
The starter relay is applied at the power on 80 A as much as possible meets the parameters. Very fast delivery thank you. Greetings.
Review translated automatically
Reliable opinion
Voltage regulator for Honda NSR 125 is very good it is easy to install the cubes fit perfectly good current feeds just buy and ride.
Review translated automatically
Reliable opinion