Forgot password
Order status
Free delivery from 150 euro
Motorcycle electrical & lighting Venbo
Simson SR 50 Skuter
Manufacturer
Price
Sort
from 2
Browse by manufacturer
Products reviews
Bulb holder in My case completely unusable without self-intervention. Crookedly assembled, the glue (weld) only in one place, which after an attempt to insert the bulb the whole thing began to fall apart. In addition, the metal plate inside which the bulb's dynx is supposed to catch is not in the correct position, making it impossible to seat the bulb properly. (It falls out by itself) After taking it apart, correcting the factory and gluing it back together somehow it is usable, but still the bulb is still not seated very securely. (Photos from the state after purchase)
Review translated automatically
Reliable opinion
Money thrown down the drain in the front lights bulbs 5W and in the original I have 21W I thought what's the problem I'll put the old ones and here's the problem they don't fit, you can't screw on the cover of the turn signal, now on these bulbs blink very quickly you need to look for the orginals
Review translated automatically
Reliable opinion
After changing the ignition from Platinum to Ducati Energy, the engine has an ignition advance and the Simson no longer runs like a typical Simson, but it turns better, fuel consumption decreased by at least 0.5l/100km. The only downside is that you have to work a little when setting it up, but overall I recommend.
Review translated automatically
Reliable opinion
My motorcycle is a Simson S51 with a capacity of 50 cm3, the above item is superbly made, looks very nice, and most importantly, you do not need to buy any screws because the item is immediately assembled and ready for use, you only need to install. I sincerely RECOMMEND !
Review translated automatically
Reliable opinion
As for the lamp it's ok, but the turn signals are already poor, two were missing bulbs and the gaskets were so hard that they cracked when putting them on, while the other two were normal rubber but the glass fit required new screws (shorter).
Review translated automatically
Reliable opinion
Merchandise does not fit sr50 because Magneto enters too deep o can not be tightened. Which results in damage to the wedge on the first firing attempt.When replacing the wedge, it turns out that there is a bigger groove in the magneto than the wedge.
Review translated automatically
Reliable opinion
Simson S51 E/4. A poorer and cheaper version of the S51 E in terms of electrical system, identical to the S51 N model. It had a 4-speed transmission. Production ended in 1988. Assembly mileage very easy.
Review translated automatically
Reliable opinion
The turn signals came to me in good condition but unfortunately I sent back due to the fact that the turn signals came on plastic mounts. The photo is not consistent with the delivered product. This was the case with mine
Review translated automatically
Reliable opinion
Fuses bought for MZ during electrical repair which admittedly burned all of them, but better fuses than bulbs I recommend buying to spare
Review translated automatically
Reliable opinion
Everything ok I recommend allegrowicz, fast shipping goods as described. Transactions with such sellers are pure pleasure !!!
Review translated automatically
Reliable opinion
All shopping on Gmoto is a pleasure. The merchandise as always of the best quality, and the delivery of the goods is prompt. I recommend.
Review translated automatically
Reliable opinion
I purchased a fuse for a 1977 WSK 125 so-called humpback. It fits, works properly. It fulfills its function. I recommend
Review translated automatically
Reliable opinion
A fuse, like a fuse, is simply supposed to work. Once installed, it simply works and does its job.
Review translated automatically
Reliable opinion
The fuse fits the original fuse holder on the WSK125. I have no reservations about this product.
Review translated automatically
Reliable opinion
You need to ream the hole for the starter cable, the sheet metal from holding the rolgaz to be replaced. Screws a mile long.
Review translated automatically
Reliable opinion
MZ TS 150 VINTAGE 1982 FITS THE VEHICLE'S ELECTRICAL SYSTEM IS FULLY OPERATIONAL AND WORKS LIKE THE ORIGINAL
Review translated automatically
Reliable opinion
everything is exactly as it should be, and I am very satisfied. marcin pierzcchała
Review translated automatically
Reliable opinion
I ultimately purchased the fuse for a WSK 125 motorcycle. So far it has served its purpose 100% and without problems
Review translated automatically
Reliable opinion
Fuses bought for universal meter very good product useful in the garage recommend to all
Review translated automatically
Reliable opinion
Simson S51, 1984, everything as described, now the installation after conversion to 12 volts is safe.
Review translated automatically
Reliable opinion
Pipe in vintage style, fits a classic (WSK 175 Kobuz). It looks nice and works properly.
Review translated automatically
Reliable opinion
The pipe fits perfectly on the original cable on the Ogar 200, it doesn't fall off or anything, it's made quite well.
Review translated automatically
Reliable opinion
Simson scooter 1980, quality on five, white cream color, size fits moped. Recommended !
Review translated automatically
Reliable opinion
Simson S51 enduro 1980r fit, everything works as it should. They do not melt, they were well made.
Review translated automatically
Reliable opinion
I have no objections to the product choc you need to do a little modification at the gas matte blocker
Review translated automatically
Reliable opinion
simson s51 confort, 60ccm, 1989. very good quality product, recommend
Review translated automatically
Reliable opinion
MZ ETZ 250 Lux, 1968. Aesthetics and quality at the time of purchase b.good.
Review translated automatically
Reliable opinion
Simson s51, 50 ccm, 1989. It was worth buying and it has changed a lot
Review translated automatically
Reliable opinion
Simson s51, 50 ccm, 1989. It was worth buying and it has changed a lot
Review translated automatically
Reliable opinion
even fuses very well packaged and labeled
Review translated automatically
Reliable opinion
Standard fuse, that's what I wanted.great
Review translated automatically
Reliable opinion
WSK 125 The product meets expectations, I recommend.
Review translated automatically
Reliable opinion
WSK 125 The product meets expectations, I recommend.
Review translated automatically
Reliable opinion
WSK 125 The product meets expectations, I recommend.
Review translated automatically
Reliable opinion
WSK 125 The product meets expectations, I recommend.
Review translated automatically
Reliable opinion
Everything ok, I recommend and greetings.
Review translated automatically
Reliable opinion