Motorcycle engine - parts
Triumph Speedmaster 865 EFI 2017

2020-07-30, 12:06

View original

Darek

The screw is made with precision. I just pay attention to the assembly! The original screw is at least twice as long. The torque recommended in the service book (43Nm) is far too much for a Yamaha Thundercat, fekt is a broken thread.

Review translated automatically

Reliable opinion

2020-08-03, 18:02

View original

Rogério

I got an yamaha xt350 of 1991. I am very glad with this item. Very good quality / price. Recomend it.

Review translated automatically

Reliable opinion

2020-03-01, 11:24

View original

Mateusz

Replacement with JMP plates helped, I used them in the Triumph Rocket III as to the quality I can only say after a longer use so far everything is ok and from the appearance and external treatment looks good probably I would know more if I measured it with a micrometer screw and for example hardness but I did not do this only after putting it on I measured the valve clearances again and checked that they met my initial assumptions . After replacement the motorcycle again runs quietly and ignites without any problem on the shot greetings

Review translated automatically

Reliable opinion

2021-02-05, 07:32

View original

Marek

Hello, I recently purchased some bearings shown in the ad. They were mounted to the scythe in the mtd tractor. SKF bearings have good strength and fit perfectly in the places for them. The advantage of the product is all kinds of uses, they perform well in any equipment. I recommend to purchase this product. Greetings

Review translated automatically

Reliable opinion

2024-09-19, 08:55

View original

BOULET-DESBAREAU

The product is very similar to the original. The only fault is that the threaded end is too short compared to the original. It's missing about 5 to 8 mm. This damaged the threads on my housing. I had to dismantle everything and redo the threading with ilsert.

Review translated automatically

Reliable opinion

2020-08-18, 22:09

View original

Jakub

When purchased, the bearing had no play, as befits a new bearing. The bearing has many uses. They can be mounted to wheels that are equipped with a drive on which a very high force acts. This bearing will 100% last more than a typical Chinese bearing.

Review translated automatically

Reliable opinion

2020-11-22, 15:13

View original

Jacek

Yamaha XVS 1300 CU year 2014 The bolt is shorter than the original and does not hold the size of the original bolt. It should not be indicated to fit this model. The only use for it is a copper gasket.

Review translated automatically

Reliable opinion