Motorcycle engine - parts
Yamaha SR 500 G 1979

2024-05-20, 11:19

View original

MKT

Such a masterpiece of technology I have not seen, even the reaction of the gentleman from the grinding shop was as if he saw at least a gold bar. The quality of the product is very good, and the installation instructions are included, in general, the product is worth recommending, moreover, what is there to write high performance .

Review translated automatically

Reliable opinion

2022-04-27, 23:16

View original

Adamsky73

WSK M06 B3 1979. The puller made exemplary. So far it has been used for two WSK engines and has performed sensationally. This tool is indispensable in small as well as large workshops.

Review translated automatically

Reliable opinion

2025-07-04, 05:46

View original

Markku

The price/quality ratio is good for recreational use ... Of course, in the case of the Honda Transalp valve adjustment tool, a small modification has to be made to the tool itself, i.e. an anatomically correct bend in the wrench stem is easy to make yourself due to the soft material, so it is better suited for use from the service hatch, no need to remove the valve covers from the body, but can be used for the valve adjustment "service props".

Review translated automatically

Reliable opinion

2023-05-24, 10:46

View original

Dawid

A great copper washer for the oil drain bolt. Its main advantage is the right hardness. When tightening, it undergoes plastic deformation, so it perfectly fulfills its role - seals. Beware of washers made of copper alloys. Some of them are so hard that they do not yield even when hit with a hammer - they are not suitable for sealing the oil drain.

Review translated automatically

Reliable opinion

2022-05-16, 10:06

View original

Damian

Honda VT600C, the wrench is made of good steel, the "squares" cut in it perfectly fit the valve adjustment screws, 3x3 and 4x4 mm - most motorcycles have just such screws. This is an indispensable tool for someone who services his unicycle himself. Thanks to the fact that it is quite long and thin - it allows very precise adjustment of valve clearances, no more pliers!

Review translated automatically

Reliable opinion

2021-02-07, 13:11

View original

RDS

Some time ago I began to apply the principle of replacing copper washers at the time of oil change (previously I burned out). I must admit that for 1 zl it is not worth fighting with the old washer, especially since you will not get the same effect as with a new one. Now I treat the washer as a mandatory set - I always buy a set of oil + filter + drain bolt washer.

Review translated automatically

Reliable opinion

2023-08-18, 11:07

View original

Artur

Everything ok full professionalism and fast delivery ( everything original) plus for remembering the motorcycle on the website and selecting parts by the selected version I will definitely use this store in the future I recommend it

Review translated automatically

Reliable opinion

2016-06-05, 21:55

View original

Kamil

yamaha yz 400 f; after the replacement, the motorcycle gives off its power quite differently.

Review translated automatically

Reliable opinion