Forgot password
Order status
Free delivery from 150 euro
Motorcycle fuel system - parts
Jawa TS 350
Browse by manufacturer
Products reviews
To get it to go on the faucet well you need to heat as it is any fuel line, it fits as it has. Photo of my Romet Ogar 200 under restoration assembled on parts from Gmoto.pl :)
Review translated automatically
Reliable opinion
I OWN A JAWA TS 350 , SIMSON S51 AND MZ ETZ 250 . BOUGHT ITEM MET MY EXPECTATIONS , THE INSTALLATION WENT WELL - NO PROBLEMS.
Review translated automatically
Reliable opinion
I OWN A JAWA TS 350 , SIMSON S51 AND MZ ETZ 250 . BOUGHT ITEM MET MY EXPECTATIONS , THE INSTALLATION WENT WELL - NO PROBLEMS.
Review translated automatically
Reliable opinion
I OWN A JAWA TS 350 , SIMSON S51 AND MZ ETZ 250 . BOUGHT ITEM MET MY EXPECTATIONS , THE INSTALLATION WENT WELL - NO PROBLEMS.
Review translated automatically
Reliable opinion
Mz etz 250 material good and workmanship Great nice appearance, workmanship aesthetic. I recommend!!!
Review translated automatically
Reliable opinion
The writing on the box "high quality" from the start suggested that the yellow hands would take no prisoners. I was not wrong. 1. needle thicker than the original by more than 0.3mm. Impossible to insert into the throttle without machining. I tried with five throttles. Even into the most broken one it did not go in. 2. float pin - same story. 3. main nozzle - 80 (should be 92), suction - 78 (72), no pilot nozzle markings. 4. throttle cover gasket crookedly bumped. Rubbish.
Review translated automatically
Reliable opinion
I knew it was Chinese, but I did not expect that so much:) Before the first installation, it is necessary to disassemble the entire carburetor and clean it from the filings and chips that the Chinese left. It is worth tightening all the nozzles, because in my case, after the first unsuccessful attempts to fire up, it turned out that the nozzle, like a fish, was swimming around in the float chamber. To correct also the suction plate, which in my case, did not hold the suction in the open position. After inspection and corrections, the carburetor works properly.
Review translated automatically
Reliable opinion
The gasket looks good, the rubber is of good quality, but the final gasket is not suitable for the TS 350 java. It is shorter than the factory one by a few millimeters, which means that based on the application of another paper gasket of the spigot the gasket will not press the carburetor to the spigot. The carburetor was catching left air I had to put on the old original gasket. The product as a replacement does not meet the functional qualities of the original. Aesthetically it looks very good.
Review translated automatically
Reliable opinion
I own Motorynka Romet Pony M-2 Motorcycle.The capacity of the engine is 49.8 cm, and the year of production is 1980.The product made in very good quality, I recommend to all buyers. I have already ordered Motorcycle parts from this store a couple of times, and not only for Motorynka, but for other Motorcycles too.I think that's enough, the products from this store I rate 100%.There were no delays with the shipment, or any complications, I recommend to all buyers!
Review translated automatically
Reliable opinion
I own a motorcycle brand Jawa 350 TS. Purchased by me carburetor is practically no different from the original as for the replacement is quite well made and fits the motorcycle without any problems after a small adjustment of the fuel level can be calmly mounted to the motorcycle and on the road. carburetor as for replacements this price I can safely recommend to any one user motorcycle Jawa 350 TS
Review translated automatically
Reliable opinion
Rubber connecting the carburetor to the air filter unfortunately does not have a good reputation. Rubber very hard, not flexible at all, and when trying to insert , under the influence of fitting into position - it cracked.I suspect that either this product has been lying on the shelves of the warehouse for 20 years and the rubber has faded, or the components of the rubber badly matched. Something is wrong, if, when trying to insert it cracked.
Review translated automatically
Reliable opinion
With a diameter of 6 mm and a length of 50 cm, the fuel line is a solidly manufactured component that ensures reliable fuel flow. Its flexibility makes it easy to install, and its fit with standard dimensions makes it a practical and universal solution. Thanks to it, you can be sure of the smooth operation of the fuel system, which positively affects the performance of the vehicle.
Review translated automatically
Reliable opinion
Nice kit albeit not many parts in it, could use more of them. I think the floats were misaligned or got twisted during shipping. I got two souls I think from the slow speed not signed so I do not know what they are. In general it could be But if I gave a full set with all the nozzles nozzles nozzles and other things would be nice
Review translated automatically
Reliable opinion
Hello I own a 1989 Jawa 350 TS motocrosser and unfortunately the carburetor rubbers original have become hard I bought new ones, put them on, everything fitted super well, and now the engine works superbly at low revs. I bought new ones and now the engine works superbly at low revs.Thank you and greetings .jarek19121
Review translated automatically
Reliable opinion
A carburetor for £60 I expected something auntie better, but: -the floats do not have a full range of movement -there are traces of machining inside -it stinks until your head hurts -unsigned nozzles making it unclear if they are the same as in the old one or some others It could be better. As it did not fire so it does not fire.
Review translated automatically
Reliable opinion
My motorcycle is a late 60's/early 70's railroad diesel drainage truck with an engine from an IŻ-56. We bought this carburetor and it is MEGA! Wonderful adjustment, perfect flow, great workmanship. Happy New Year wishes Karol Lubaczewski President of the Society of Friends of the Krosniewice Commuter Railway
Review translated automatically
Reliable opinion
I own a jawa 350 de-lux and I put on a carburetor from ts, the purchased carburetor works perfectly, the jawa fired up immediately after installation and pouring fuel, I did not have to adjust anything, more than that on this carburetor moto has better acceleration and spins more vividly. 100% satisfaction
Review translated automatically
Reliable opinion
The supplier showed professionalism in the preparation and delivery of the shipment. The electronic notification system of the status of the order until delivery to the addressee made a very good impression. very fast delivery And that without a courier.
Review translated automatically
Reliable opinion
Jawa 50 Mustang 79r. The fuel faucet enters with a slight play, the mesh does not seem to be well seated there is a feeling that it may fall off with some larger shocks. The rest of the faucet, including the nut, is well made and fits into the original holes.
Review translated automatically
Reliable opinion
Jawa 50 year 1980 faucet itself casting made so well. The filter (mesh) barely holds together even a little torn I do not know if it will work well. In addition, this filter can not be put well on the faucet holds on "word of honor".
Review translated automatically
Reliable opinion
Very cool kit. It includes, in addition to gaskets, nozzles, adjustment screws, needles, float. Most of the available carburetor repair kits contain only gaskets. Recommended. Fast, efficient, reliable, for the pocket is also convenient.
Review translated automatically
Reliable opinion
The filter has a very cool reusable solution. It can be taken apart and blown out, which is a big plus. After several such treatments, the filter continues to be tight, no fuel leaks from it. I highly recommend
Review translated automatically
Reliable opinion
I own a Jawa CZ 350 year of production is 1985.When ordering the rubber connecting the carburetor to the air filter, I did not expect such a quality rubber. Mounting passed without any obstacles. In my opinion, it serves its purpose.
Review translated automatically
Reliable opinion
A good, solid guide ;)
Review translated automatically
Reliable opinion
Suzuki Rmx 50/70 rmx 2001. It was very easy to put on and works well. It puzzles you that it is a different rubber and a different motor rally, so I do modifications to make it spin,that is just drive faster, crazier, etc.
Review translated automatically
Reliable opinion
I have a Jawa 350 motorcycle (my first motorcycle) capacity 350 from the year 1983, purchased carburetor rubber product fit as needed, did not cause any trouble during installation, will serve a long time, because it is made of good material. greetings.
Review translated automatically
Reliable opinion
Copper washer, round. Such as I dreamed of ;) Although when I wanted to mount it, it turned out that it is not required. I'll leave it for myself as a souvenir and return to the store as I do every time. Full professional
Review translated automatically
Reliable opinion
Gasket after installation ok, but after contact with gasoline increased its size. I needed to leave quickly and trimmed on the outside. It did not do much, had to be sent back for complaint. My fault.
Review translated automatically
Reliable opinion
Very flexible, perfectly fits the Mosquito, allows you to replace old hoses that have already lost their flexibility. Easily cut to the desired size for a perfect fit.
Review translated automatically
Reliable opinion
Jawa ts 350 638 Unfortunately I received a nozzle in the set with too small size, I no longer remember which one, fortunately I found in the garage from old stocks good. gaskets, float and valve ok.
Review translated automatically
Reliable opinion
CZ 350 type 472.4 1979. needles, screws, springs as much as possible ok. Nozzles for 350 are not suitable, the slow speed nozzle is in a tolerable size (although this size is missing), the main nozzle is not.
Review translated automatically
Reliable opinion
Moped Jawa 20.Between the screwed parts in the faucet is a rubber gasket and it should be hard.With a rubber one you can not twist to the stop and the faucet slightly moves after installation.
Review translated automatically
Reliable opinion
I highly recommend. Faucet in appearance identical to the original. Good part for motorcycle restoration. It works it should not leak. In a word, a good part for little money.
Review translated automatically
Reliable opinion
Nothing to say the truth the best page for motorcycle lovers jawa had a carburetor that did not serve me and now with these parts is new hehehehe super quality
Review translated automatically
Reliable opinion
I own a motorcycle jawa 350 model 634 so called iris replacement faucet Jikov is good aesthetic easy to install meets the expected requirements I am very satisfied
Review translated automatically
Reliable opinion
The filter fits the Jawa Mustang very nicely. Small, not chewing si3 in the eyes like the paper ones. I think it's worth paying the extra 3-4zl. Nothing si3 is airing up. I recommend
Review translated automatically
Reliable opinion
Gasifier repair kit has defects only two nozzles matched and float rest for example, one nozzle was not from this carburetor float valve was suspended, etc.
Review translated automatically
Reliable opinion
Faucet very good especially for Java the filter inside protects from various impurities. The faucet does not leak I can happily recommend it.
Review translated automatically
Reliable opinion
Filter prima sort. Elegant looking . Fulfills its function I recommend to all who own old mopeds or even lawnmowers.
Review translated automatically
Reliable opinion