Motorcycle parts
ATV China Bashan BS200S-7A 200 4T - Page 5
Manufacturer
Price
Sort
rozmiary:
Browse by manufacturer
Products reviews
2019-12-20, 08:50
Marek
Zipp quantum gt5 2013 I ordered two xeon bulbs. And when they reached me. One of them had a crooked shade (It's the blue glass). I put it on without touching the glass with my hands, of course. It was fun, but it ended quickly after 7 minutes of driving I had to go home on stoplights because there was a short circuit in the installation. I checked what was wrong and it turned out that one had reached the end of its life (visible in the photo). There was a horrible sweet smell coming out of the lampshade as well as from that bulb even though it didn't look burnt, that's what it was. And the 2 also did not want to be alone and 15 min of driving also made a short circuit and would not light up. Interestingly, the same smell accompanied 2, so from this I deduced that it was burnt and even swapping its place in the lampshade did not help.
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2021-06-29, 17:34
Marek
I have an ATV KAYO 200, I had to replace the vacuum faucet because it took too long with the starter to fill the float chamber, the installation required an additional bracket, the quality of the pass-through faucet is good, only the markings on the body are Chinese, but this is not a problem for me. Greetings Marek
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2020-07-07, 18:45
Mikołaj
Yamaha XT125r from 2010r. There were no problems with the installation of the tank, only the hose was a little too long, I shortened it and it is great. The tank seems to be solid for the price. I am satisfied, regards ;)
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2023-10-29, 11:32
Boszu
I measured the old line as far as I could and it seemed that the length of the one here would be the same, especially since only two such lines with the ends I need have this dimension. Everything on paper wanted to match, but when the line arrived, I took out the old one, put in the new one and surprise, there was a rapturous 2-3cm missing. :P Fortunately, it's only 2-3cm so I was able to run the line a little shorter than if the older one. Thanks to which, on contact, managed to put it on. And personally, I recommend, however, spare no time, pull out the old line and to the nearest centimeter or even millimeter! Measure the old line, so that you do not have similar surprises. :) Besides, the line itself lux raspberry! ^^ Only the bend of the tip is 90', where in the photo it looks like a more obtuse angle, e.g. 135'.
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2023-02-18, 10:44
Jacek
The fan went to the Bashan BS250S-5 in the version without an oil cooler. It would seem that it is just some flimsy "blower", but it really does quite a job! If the quadcopter is used for household work pulling trailers, etc. tasks. It definitely reduces its temperature. The only thing that I could complain about is a little too short cables. And I had to extend them by about 5-8cm to get to the factory connector. Other than that, I RECOMMEND! :)
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2020-05-14, 22:09
Przemek
WRONG!!! If someone has nothing to do with money this is a great choice. After firing it came 2s and burned. And long and short. It is better to buy any for 5 zeta sle zeby it works. I heartily do not recommend. In these piebiadzach I recommend something that works and not something thanks to which you will have to return from a night ride without lights. Expensive, does not work, no sense, I do not recommend and sympathize with the buyers.
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2016-01-01, 15:35
Krzysztof
I own a Romet C1 moped. I was positively surprised by the power of the light and its pleasant color. Unfortunately, it blinds other drivers and I changed to my old 25W "bubble". My "motorcycle" does not have high and low beam in separate shades,so I can not give it as a road light, however, if you own a cross etc., I recommend it. Mine is already waiting for this fate, only the cross is still missing
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2021-05-27, 08:23
Sebastian
My machine is a Bashan 250 I ordered a windmill to try to cool the engine a little more the windmill is very substantial and it works out the installation went quickly and smoothly so I am 100% happy with the product but to continue doing what I love I need to invest more money for a new harness because my wires burned out :(((
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2021-08-31, 09:28
Marek
Hi, not long ago I bought these pads for my mrf 140 rc due to the fact that my orginal ones have reached the end of their life. I have been riding on them for about two weeks and so far they brake very nicely. The wheel stops without a problem they don't wear out as fast as the previous ones. And one of their big advantages is the price is really low. I recommend.
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2023-12-28, 09:31
Krzysztof
The only module well suited for 250 cc, 167FM engine. Stable operation throughout the rev range. It sets the slow revs well and smoothly enters higher revs. I recommend this product, others, although in the description also dedicated, unfortunately did not work. The only downside is that there is no description, no specification, to be sure of the purchase.
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2025-04-02, 16:44
urpheant
Good quality gasket pouch for a ridiculously low price, like all the parts you can find on gmoto. One small drawback: I had to cut the gasket on the clutch side because my clutch pinion was rubbing against it, but since the gasket on the clutch side has a large edge, there's a lot of gasket surface left once it's cut.
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2018-04-24, 18:15
Kurczak
shock absorber I used for a Chinese cros 200 cm consistent with the original is very strong I have an elongated control arm and this shock absorber copes very well, the aesthetics of performance very good made solidly fit in the original mounts nothing I had to weld or cut I recommend this product
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2018-02-07, 18:36
Bartosz
Brake pads purchased for motorcycle sachs ZZ 125.They fit perfectly in 100% match the description.Made with high accuracy, covered with varnish which in combination with such an attractive price will certainly satisfy any motorcyclist who takes into account the quality/price ratio.Greetings and recommend Bartek
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2023-05-15, 11:15
Ewa
The product as described. I use the products of this company and I am satisfied. The staff will always advise to buy accurately and not to send back. I recommend and encourage you to use the service because it is worth it. Always products purchased were good and matched to any equipment.
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2017-05-14, 11:15
Marcin
I ordered an eight-coil, five-wire spark igniter for my engine Z S 162 F M J. Stator has the same parameters is the original, dimensions quality workmanship commendable goods met my expectations. Works flawlessly, wires longer than the original which is an advantage
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2021-04-29, 09:22
Rafał
I own a quad atv with a power of 250 . Pads made of very good material, probably with an admixture of copper, they are very durable do not peel off quickly like the rest of the "hardened" pads ;) I recommend, I will definitely use this company when buying more parts for my quad ;))))
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2017-06-16, 10:28
Michał
The bulb burned out after a kilometer driven. After lighting it up, a white residue appeared inside, which did not herald anything good. After a kilometer driven, the bulb to be thrown away. I went back to the factory one. It works all the time, and it has not been replaced since the beginning., Zumico GR 200
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2019-01-27, 20:16
Paweł
Bashan 200 I recommend the company really the lead time is very fast and the quality is very good a set of gaskets and many other things I bought here fit perfectly I assemble a lot of engines and I always shop here because I know it will fit and be nice to assemble without corrections
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2016-06-04, 17:52
Przemysław
I purchased valve seals for a 150cc quad. I also bought a starter and a set of gaskets also for this quad. With the quality of the parts I bought so far I am satisfied. As for the seller also no reservations. Fast shipping and hassle-free. I recommend.
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2022-01-23, 07:32
Dawid
Kit good, everything that is in the photo is included. It is worth getting additional o-rings for the starter and starter cover, as well as a strainer/oil "filter" nut. The rest of the kit is included, except that the head gasket is thick, and that's a disadvantage.
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2022-01-02, 10:12
Artur
Line purchased for the quda 150cm3. Installation very easy. The 15-year-old son managed without problems. Quality very good. Replaced on a frosty day which did not affect the difficulty of replacement. The cable as well as the armor very flexible. I recommend highly.
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2019-05-10, 08:49
Rafał
The module as in the pictures with a rubber band to mount rigidly holds the module so it does not slip, well made, pin inputs ok to fit under the male cubes from the quad .spark on the plug returned after replacing the module bashan 200-s7 AC
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2018-05-10, 14:24
Mariusz
Romet crs with 156fmi 150ccm engine. The discs are well made and it is very important that the set includes new compression springs, because the old and overheated ones do not perform their function properly, and such an offer you will find only here. I recommend.
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2016-08-25, 10:11
Robert
Diabolini xb31 Quality customer service at the highest level as well as the quality of the product itself. Fast shipping and full customer awareness of what is happening with the shipment. I certainly and in good conscience recommend this store. Regards ;)
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2022-08-12, 15:27
Boszu
Simple, good and lux works in a generator. For buyers, I recommend paying attention to which way the tip on the hose is released. Because there are two versions. One has the hose released to the left, and the other, as here, to the right. :)
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2019-01-17, 14:49
Tomasz
Loncin 250 year of manufacture 2007 Ignition module fits my motorcycle,a sharp increase in power over the entire rpm range.Now colleagues smell the stench of exhaust fumes and have no chance to me.They all said that they also buy this module.
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2017-08-13, 16:41
Mateusz
Barton Sprint 2016r after putting it on and firing up the motorcycle it turned milky inside, after driving 2 km the short burned and after driving another 2 long. I am very disappointed, I was hoping for something more but oh well.
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2017-04-06, 19:59
Alicja
The pads I ordered from you are really great quality. I drive about 60km every day and the signs of use are almost not visible at all. I have been ordering parts from you for several months and have not yet been disappointed once
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2022-01-29, 10:33
Oskar
The product is very well made and preserved, there is no right to get any corrosion in front of the cleaner, very well packaged and the quality is very high, it fits and looks good, I highly recommend it
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion
2024-05-24, 06:12
Olaf
The rear brake pads are a super product because of the elegant workmanship. It holds together and I think it can serve me for a long time. I will definitely be ordering more from the store for various parts because of the large selection and super workmanship.
Review translated automatically
-
Esthetics:
-
Material quality:
-
Fitting:
Reliable opinion






































