Motorcycle parts
BMW R 850 R 2002 - Page 4

2024-10-09, 13:17

View original

Wiktor

It sits in my neos as well as simson and I can not say a bad word about it. If it wasn't good I wouldn't buy it a second time. I recommend

Review translated automatically

Reliable opinion

2019-05-11, 09:46

View original

Ireneusz

BMW r1100rt from 1997 I have already done 20000 km and it is cool, I am currently putting the same disc on a friend also for BMW rt1100

Review translated automatically

Reliable opinion

2019-04-13, 21:13

View original

Mariusz

I am a very satisfied owner of a 1995Yamaha XJ 900 Diversion motorcycle.The vehicle is absolutely trouble-free but due to its age, the swingarm bearings had to be replaced.I purchased a set of Tourmax bearings.The bearings and the simmering rings supplied in the set matched perfectly which made the replacement a pleasure.Now my equipment rides like new again.I would recommend this set to anyone who has a similar fault to eliminate in their equipment.If all the parts were made with such accuracy, I could boldly become a mechanic ;)

Review translated automatically

Reliable opinion

2020-12-25, 00:18

View original

Marcin

The product met my expectations, the workmanship is very good with no imperfections. The price is adequate to the quality, it is better to buy one for 15 than 3 for 5 Chinese, which will fall apart after 150 km of driving. Water resistance is, proved it to me last weather when I drove into a decent puddle at 50 km/h Hurricane did not even hesitate. Assembly slightly falls out to warm up on a radiator, because such a cold rubber from the courier to fit is a nightmare.

Review translated automatically

Reliable opinion

2021-09-13, 22:50

View original

Patryk

For Romet Zetta 50 fits like a glove - it looks identical to the Chinese original. The rubber cover on the side of the high-voltage cable, admittedly, is hard to enter the cable, but this is an advantage in my opinion - it reduces the risk of moisture getting inside. After installation, the difference is unbelievable, the spark on the spark plug has improved, it is strong, and there is no phenomenon of "falling ignition". I recommend!

Review translated automatically

Reliable opinion

2020-05-03, 00:23

View original

Maciej

Wsk 125 The frame is nice, you can't expect more from a plastic metallized one. It fits my wsk-i nicely. The only big minus is that it did not fit completely in the holes - I had to widen the holes with a drill both at the top and bottom. Other than that, installation was easy. I recommend the product for those who don't mind making up holes.

Review translated automatically

Reliable opinion

2020-05-31, 09:42

View original

Miklós

A weboldal tökéletes, minden igényt kielégítő. A szállítás még így is, hogy nemzetközi (Lengyel - Magyar) gyorsabb volt, mint sokszor Magyarországon belüli szállítás. A kifizetett alkatrészekről, a csomagom állapotáról folyamatos jelzést kaptam. Az alkatrészekkel 100 %-ban elégedett vagyok :-) *****+*

Review translated automatically

Reliable opinion

2019-10-18, 08:20

View original

Tycjan

Bmw R 1100 RT 2000 year, I purchased a set of consumables. Very friendly, professional service and advice. Competitive prices. They respond to emails. You are kept informed about the shipping status. This was my 3rd contact with the company. I recommend, I will certainly use again more than once. Regards, Tycjan

Review translated automatically

Reliable opinion

2021-05-08, 07:38

View original

Andrzej

Plastic license plate frame looks like a good chrome material I changed the plate because I became the owner of a Suzuki Intruder VL 125 2000 year all in all. Looks super material fine that's why the price very low ugly comes longer.

Review translated automatically

Reliable opinion

2014-09-11, 21:30

View original

Jerzy

I have been shopping with this seller for a long time and each time I am very satisfied with the quality, speed and contact with the seller. I have already recommended several offers to my friends, who are also very satisfied.

Review translated automatically

Reliable opinion

2019-06-17, 07:58

View original

Damian

In the category of quality/price very nice frame. Strong plastic imitating chrome. Aesthetics at a high level. Lightweight and durable And the license plate enters on contact ( for me a plus because there is no slack). I recommend

Review translated automatically

Reliable opinion

2021-08-11, 16:02

View original

Roman

Suzuki DR 125,a friend's motorcycle, ALL BALLS seals are not my favorite company, they are often difficult to install, it is often necessary to heat the shin to get the sealer to pop into place.

Review translated automatically

Reliable opinion

2016-01-12, 20:17

View original

Rafał

Romet Ogar 205, year of production 1987.NGK is NGK, quality in itself, I changed and the firing problem disappeared. Pipe precisely made, matches the rest of the ignition system components.

Review translated automatically

Reliable opinion

2019-04-12, 07:04

View original

Rafal

I own a motorcycle Daelim Daystar vl 125 prod. year 2006 . Lag seals from ATHENA was a successful purchase because they eliminated leakage from the shock absorbers. Easy and quick installation.P olecam.

Review translated automatically

Reliable opinion

2020-02-03, 14:49

View original

Patryk

Suzuki katana ay 50 (2006) The fit of the pipe is very good, the plug is designed for a candle without a cap, sealed ends prevent water from getting inside.

Review translated automatically

Reliable opinion

2017-09-04, 10:25

View original

Mariusz

frame very nice, put on jawa ts 350 looks very good on this motorcycle, installation also very pleasant immediately changes the name of the motorcycle adds better charm

Review translated automatically

Reliable opinion

2024-09-25, 05:27

View original

Filip

Very good solution for those who want to replace the license plate frame with a new one. The price is very affordable. The quality of workmanship is also flawless. I can recommend

Review translated automatically

Reliable opinion

2024-09-19, 07:03

View original

CHASLES

Fits new tubes without a hitch, and after several km on normal roads, no leaks to report. We'll have to wait and see how the rubber ages over time.

Review translated automatically

Reliable opinion

2018-07-06, 13:55

View original

Karol

Cool brand NGK. Fits perfectly in place of the factory one, gives a good spark. Thanks to the 2 protectors do not get moisture in the wires and candle. I recommend !

Review translated automatically

Reliable opinion

2019-07-03, 21:51

View original

Krzysztof

Quality at a high level. Included are sealing rubbers so that water does not get under the spark plugs or between the high-voltage wire and the pipe.

Review translated automatically

Reliable opinion

2017-04-16, 21:04

View original

Grzegorz

Shl m11 1961. Nothing to add, nothing to take away, the pipe sits like this and the extra protective rubbers should protect well against water and possible punctures.

Review translated automatically

Reliable opinion

2024-05-03, 08:21

View original

Magda

Sealers fit varadero 125 2002, workmanship ok, trouble-free installation. So far the suspension works ok, we'll see how long they last.

Review translated automatically

Reliable opinion

2023-06-26, 15:34

View original

Przemysław

Professional approach to the customer, assistance at every stage and reliable. Express service, quality at the highest level, great and close-knit team.

Review translated automatically

Reliable opinion

2016-07-31, 17:56

View original

Dariusz

I bought 2 pipes for a Romet Pony and a Chinese Moto Ventus scooter for both of them, I also bought NGK plugs and the startup of the motos improved immediately

Review translated automatically

Reliable opinion

2022-04-24, 13:31

View original

Krystian

Motorcycle enduro Beta RR 50 delivery went smoothly Sealers easy to install and despite riding on heavy terrain do not let go I recommend highly.

Review translated automatically

Reliable opinion

2023-06-30, 12:51

View original

Rafał

Recommended. The product is consistent with the photo. Carefully packed in foil, you can see that no one rummaged at it. Very good quality for the price.

Review translated automatically

Reliable opinion

2021-06-23, 21:07

View original

Łukasz

Goods very well packaged and protected in a clear box, you can see what you are buying made solidly and with good materials. Recommended.

Review translated automatically

Reliable opinion

2017-07-23, 09:59

View original

Michał

It fits the ETZ 250 very well. It is made of rather good material, the plug sits firmly - there is no possibility of 'popping out'. I recommend.

Review translated automatically

Reliable opinion

2025-09-18, 10:04

View original

ΔΗΜΗΤΡΗΣ

It has nickel finish but its plastic, the article says metallic but thats wrong, if you want it for enduro bike or adv its not metallic

Review translated automatically

Reliable opinion

2020-09-14, 20:18

View original

Grzegorz

Goods of the highest quality. Good workmanship fast delivery affordable price. I really recommend.Like a part and for a motorcycle it is only GMOTO!!!

Review translated automatically

Reliable opinion

2020-10-04, 21:49

View original

Wojciech

Romet ogar 205 What can I say pipe from a good company I use with all my motorcycles and there has never been a problem with them. I recommend

Review translated automatically

Reliable opinion

2018-05-07, 18:15

View original

Magdalena

WSK M6 B3 1982 Very good quality product easy to install. Fits perfectly, looks very good. Frame worth recommending.

Review translated automatically

Reliable opinion

2024-09-21, 19:12

View original

SEBASTIEN

Installed and functional: nothing to say. Good value for money. Quick delivery. Package was in good condition. Would recommend.

Review translated automatically

Reliable opinion

2017-06-23, 12:38

View original

leszek

The kit fits KMX 125 without any problems. 74zł is the cheapest option I found. I recommend. The motorcycle again goes where I want it to go.

Review translated automatically

Reliable opinion

2018-10-23, 18:45

View original

Karol

I own a 2004 Yamahe dt 50 r.The product made very well easy to install.The product did its job as much as possible.

Review translated automatically

Reliable opinion

2024-08-18, 08:09

View original

Wojciech

Good quality bearing . Perfectly fitted ,very good replacement.I hope it will also last as long as the original. Pecam

Review translated automatically

Reliable opinion

2023-08-14, 15:03

View original

Janek

I have not yet assembled and do not know how with the fragility of the plastic, but from the outside it looks positive. On the back a slight unpainting.

Review translated automatically

Reliable opinion

2020-05-04, 10:22

View original

Mirosław

BMW R1150 RT 2002 YEAR, the replacement went quickly and without any difficulties, gaskets very good according to my expectations

Review translated automatically

Reliable opinion

2024-09-21, 14:24

View original

Alexander

Works exactly as it should, have been using it ever since I bought it because my old one was a piece of crap, no complaints from here?

Review translated automatically

Reliable opinion

2016-06-19, 09:21

View original

Dominik

One of the few decent pipes available on the market. The spark jumps only between the electrodes of the candle and not where it wants.

Review translated automatically

Reliable opinion