Forgot password
Order status
Free delivery from 150 euro
Motorcycle parts
Ducati ST4 916 Sporttouring - Page 5
Manufacturer
Price
Sort
€3.33
Lowest price from 30 days before discount: €3.50
Athena 29.6x0.15 exhaust manifold gasket - S410110012003/1
Options +4 
€116.43
Lowest price from 30 days before discount: €129.37
DID 525 ZVMX 102 X-Ring open drive chain with lugs
(12) 
Options +3 €23.77
Lowest price from 30 days before discount: €25.02
JT steel rear sprocket JTR745.39, 39z size 525
€8.22
Lowest price from 30 days before discount: €8.65
HifloFiltro HF 153 Cagiva/Ducati oil filter - HF153
(2) 
€6.36
Lowest price from 30 days before discount: €6.70
Athena 43x54x11 front suspension seal set - P40FORK455056
(3) 
€15.24
Lowest price from 30 days before discount: €16.05
Athena 43x54x11 NOK front suspension seal set - P40FORK455093
(1) 
Podobne:
from 5
Browse by manufacturer
Products reviews
I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.
Review translated automatically
Reliable opinion
I purchased the filter for the Ducati Multistrada 1100.The product is original, worthy of recommendation. It meets its expectation. This is the umpteenth filter ordered from the same filter and, as usual, once again I am satisfied. I recommend to everyone as much as possible. After all, Made in Italy products are of the highest quality and worth buying:) Regards
Review translated automatically
Reliable opinion
Wsk 125 The frame is nice, you can't expect more from a plastic metallized one. It fits my wsk-i nicely. The only big minus is that it did not fit completely in the holes - I had to widen the holes with a drill both at the top and bottom. Other than that, installation was easy. I recommend the product for those who don't mind making up holes.
Review translated automatically
Reliable opinion
Plastic license plate frame looks like a good chrome material I changed the plate because I became the owner of a Suzuki Intruder VL 125 2000 year all in all. Looks super material fine that's why the price very low ugly comes longer.
Review translated automatically
Reliable opinion
In the category of quality/price very nice frame. Strong plastic imitating chrome. Aesthetics at a high level. Lightweight and durable And the license plate enters on contact ( for me a plus because there is no slack). I recommend
Review translated automatically
Reliable opinion
As it is Athena seals are doing a cool job, 0 leaks so far, every moto of mine so far has just had Athena seals/rings and it has always been git.
Review translated automatically
Reliable opinion
frame very nice, put on jawa ts 350 looks very good on this motorcycle, installation also very pleasant immediately changes the name of the motorcycle adds better charm
Review translated automatically
Reliable opinion
Very good solution for those who want to replace the license plate frame with a new one. The price is very affordable. The quality of workmanship is also flawless. I can recommend
Review translated automatically
Reliable opinion
2014 Honda CRF 250 M Worn with oil to make it go in easier. They fit well, the suspension does not leak. At the next change I will also choose them.
Review translated automatically
Reliable opinion
WSK M6 B3 1982 Very good quality product easy to install. Fits perfectly, looks very good. Frame worth recommending.
Review translated automatically
Reliable opinion
I have not yet assembled and do not know how with the fragility of the plastic, but from the outside it looks positive. On the back a slight unpainting.
Review translated automatically
Reliable opinion
The frame mounted on the motorcycle and from today it pleases the eye, I did not want to drill the boards and with the product I am satisfied.
Review translated automatically
Reliable opinion
Suzuki DR 350 1992 gaskets very well made, fit in the original lagi, installation seamless, recommend.
Review translated automatically
Reliable opinion
Very fast shipping parts fit perfectly everything needed for the motorcycle can be found I recommend
Review translated automatically
Reliable opinion
Perfect fit. Good workmanship for little money.
Review translated automatically
Reliable opinion