Motorcycle parts
Honda CB 450 K 1974

2024-03-04, 06:57

View original

Łukasz

Interrupter already after the first use. In the previous factory deep burnout so went to replace with this one. I installed, adjusted the gap , took to setting the ignition point on the "beeper" into the multimeter and silence. I shorted the contacts and still silence. I cleaned the contacts with dry paper , silence. With damp, no conductivity. I washed with nitro, does not conduct. I wiped with sandpaper 2500 dry and wet, does not conduct. Then 1500 and finally 800, it began to conduct. That is, there were non-conductive oxides on the contact surface. Unfortunately, the sandpaper made scratches. Delicate but nevertheless and the current will already gush and burn there. Contact adhesion with a slight clearance in the plane perpendicular to the axis of rotation. I corrected by bending with pliers. In the other plane OK. The contacts overlap the entire surface. Hammer with a high projection. The screw for attaching the cable works. It has an additional copper strip under the spring, improving conductivity. Goods comparable to the original although Made in China product. Trouble-free for the ignition drove the first 200km. What kind of service life it will come out after tens of thousands of km, but about that I will not write here anymore.

Review translated automatically

Reliable opinion

2024-03-04, 07:48

View original

Łukasz

Interrupter already after the first use. In the previous factory deep burnout so went to replace with this one. I installed, adjusted the gap , took to setting the ignition point on the "beeper" into the multimeter and silence. I shorted the contacts and still silence. I cleaned the contacts with dry paper , silence. With damp, no conductivity. I washed with nitro, does not conduct. I wiped with sandpaper 2500 dry and wet, does not conduct. Then 1500 and finally 800, it began to conduct. That is, there were non-conductive oxides on the contact surface. Unfortunately, the sandpaper made scratches. Delicate but nevertheless and the current will already gush and burn there. Contact adhesion with a slight clearance in the plane perpendicular to the axis of rotation. I corrected by bending with pliers. In the other plane OK. The contacts overlap the entire surface. Hammer with a high projection. The screw for attaching the cable works. It has an additional copper strip under the spring, improving conductivity. Goods comparable to the original although Made in China product. Trouble-free for the ignition drove the first 200km. What kind of service life it will come out after tens of thousands of km, but about that I will not write here anymore.

Review translated automatically

Reliable opinion

2024-09-19, 07:00

View original

Jörg

The windshield is great, but the clamps did not fit, despite the exact motorcycle type specification. The clamps are much too small for the original handlebars and it was not easy to find clamps on the internet that fit. Please check your accessories for accuracy of fit.

Review translated automatically

Reliable opinion

2025-10-27, 07:57

View original

Joel

This piston, seal and bleed screw kit enabled me to refurbish the brake caliper on my CB400 FOUR. Compatibility confirmed on the site, fast delivery and careful packaging. Very good quality, as well as being the cheapest on the market, I recommend it.

Review translated automatically

Reliable opinion