Motorcycle parts
Honda CB 600 Hornet - Page 12

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2024-07-27, 20:14

View original

Bartłomiej

Gasket is very solid almost like the original others write that it is too long but it is not a matter of that because it must first be glued to the cover and apply a small amount of silicone and then install and everything will fit perfectly and I highly recommend because in my place is like the original nothing flies, nothing sweats.

Review translated automatically

Reliable opinion

2019-03-15, 08:51

View original

Dominik

Honda varadero 125 XL. Replacement quick and easy. Candles of very good quality. The transaction went well. I recommend

Review translated automatically

Reliable opinion

2021-10-08, 12:10

View original

Artur

There is nothing to say about Hiflo and the quality of their products, so I usually choose their filters.

Review translated automatically

Reliable opinion

2021-06-29, 10:25

View original

Leszek

Honda XL 600 V Transalp. A filter like a filter, it's hard to judge it by eye. It screwed in easily and pleasantly. All indications are that it filters as God has commanded. Shouldn't there be an o-ring in the place where it is screwed onto the spigot protruding from the block? I can't hide the fact that I would be happy to win four hundred bucks because I need a clutch and cash is tight.

Review translated automatically

Reliable opinion

2020-03-30, 20:41

View original

Michał

Sealers without complaint. In a rigid and secure package a set of sealers and covers for two leaguers. Assembly trivially easy (for those who like and have an idea of DIY and small repairs). The fit is perfect. So far zero problem and the lags work perfectly in combination with Motul 10W oil.

Review translated automatically

Reliable opinion

2020-07-08, 19:23

View original

Waldemar

My machine is an 86 Honda Shadow VT 1100 . Purchased parts were not dedicated for this vintage , so as a novice user I bought blind and surprisingly they fit . Installation was no problem and the material and workmanship flawless . G Moto and product on pistket . LWG .

Review translated automatically

Reliable opinion

2017-05-15, 22:44

View original

Maciej

Patient Honda CB600F Hornet, vintage 2001, non-functioning fan switch. What can I say, a top-notch product. After replacement, the fan spins and works at its best. This radiator fan switch is a great product, I would recommend it to anyone

Review translated automatically

Reliable opinion

2019-04-14, 18:38

View original

Mariusz

KIT purchased and installed on a 1996 Honda VFR 750.Everything fit, it worked, I am satisfied. I will mention that I met with very friendly service. And I guess this is the main reason that I will be shopping there. No photo because the parts are already installed.

Review translated automatically

Reliable opinion

2023-06-28, 15:29

View original

Bartłomiej

The outer diameter of the gasket is about 1-2mm too large for the 2010 Honda CBF600, after gently spreading the outer muffle of the muffler went in by force (it is soft) and somehow got there after tightening the cybant, but the installation is troublesome.

Review translated automatically

Reliable opinion

2017-11-17, 07:02

View original

Jakub

We fitted the bearings to a 2004 Honda Hornet pc36. The installation went smoothly and the bearings seem indestructible ;) Well, but this is Mc International after all, the top shelf among parts for Japanese ;)

Review translated automatically

Reliable opinion

2021-01-24, 16:53

View original

Bogdan

I own a motorcycle honda CBR 1000F, vintage 1966, capacity 1000 cm. This is another filter from this manufacturer that I bought, and I have never had any problems with them have always served their purpose.

Review translated automatically

Reliable opinion

2021-11-07, 09:59

View original

Marek

Honda Hornet CB600FA PC 41, good quality filter, good fit, my hornet is definitely easier to breathe now. I am satisfied cheap is not but in my opinion worth it.

Review translated automatically

Reliable opinion

2022-01-11, 15:35

View original

Wojciech

XL 600VA 1987 Oil easy to use does not require instructions. I recommend this product. Very good quality product for its price. Quick delivery hassle-free service. I recommend

Review translated automatically

Reliable opinion

2020-03-30, 20:44

View original

Michał

The protections, compared to the old ones, are slightly wider, more rigid and more "expandable", which makes them fit perfectly into the groove in the lade blocking the sealers.

Review translated automatically

Reliable opinion

2020-08-08, 13:12

View original

Rajmund

The motorcycle is a honda transalp 600 1996r.The element fit perfectly without any reservations thanks to good workmanship and fit the repair went quickly and efficiently.Regards

Review translated automatically

Reliable opinion

2024-09-24, 06:41

View original

Tomasz

The filter performs its function perfectly, after pouring off the old oil you can not see any flecks, etc. Thanks to the flexible gasket, I tighten it by hand and nothing leaks.

Review translated automatically

Reliable opinion

2021-12-12, 20:14

View original

Kordian

I always buy filters from HIflo and this time, too, everything fits until nice. I recommend to trust this brand as much as possible. Gmoto as usual at a high level. XJ600

Review translated automatically

Reliable opinion

2024-05-03, 07:48

View original

Bogusław

Great sealers, they fit nice and tight even though the lag was polished, so far only about 100km after replacement but no drop on the lag, I recommend

Review translated automatically

Reliable opinion

2019-08-26, 12:15

View original

Sławomir

I own a Honda NT650V Deauville. The seals seem solid because of the 2 spring rings. The previous ones only had one such ring.

Review translated automatically

Reliable opinion

2021-08-13, 09:01

View original

Krzysztof

It works 100% pity only that the kit does not include a copper washer. To seal the connection. Other than that, the product is of good quality. I really recommend

Review translated automatically

Reliable opinion

2020-04-26, 21:15

View original

Marcin

Fits perfectly on my old venerable XJtek, from 96. No problems with threads or leakage from under the filter gasket. I highly recommend the product.

Review translated automatically

Reliable opinion

2023-05-24, 07:13

View original

Remi

Sealers well made, there was no problem with the installation which indicates well-behaved parameters. Tight, oil no longer leaks.

Review translated automatically

Reliable opinion

2021-05-18, 18:12

View original

Krzysztof

Honda CBR F3 600 PC31 year of manufacture 1995 quick disassembly as well as installation of bearings I recommend and greet you not the first and not the last purchase from you.

Review translated automatically

Reliable opinion

2020-02-11, 17:50

View original

Piotr

Sealers very good quality not some cheap plastic. There are 2 springs on each sealer. Fast shipping. Recommended.

Review translated automatically

Reliable opinion

2024-09-02, 15:06

View original

Dawid

Very good product, nicely packaged and quality also at a high level, everything fit without any problem, so the CBR F2 is already laughing :d

Review translated automatically

Reliable opinion

2021-02-16, 11:24

View original

Błażej

Gasket ordered for Honda GL500 Interstate '82, good workmanship, fits perfectly - well fitted by the store for this model.

Review translated automatically

Reliable opinion

2023-07-29, 07:17

View original

Sika

Product of good quality as always fast shipping art.I installed in Honda CB 750 Steven fifty degree of difficulty of installation 2/5 I recommend

Review translated automatically

Reliable opinion

2024-05-03, 12:08

View original

Rafał

Oil filter OK, fits my moto. Just tear off the protective film and you can install, the seal is already lubricated.

Review translated automatically

Reliable opinion

2019-07-07, 20:53

View original

Bartłomiej

All ok, well fitted already a few thousand km behind me and all well sealed, nothing sweats Honda CBR 600 F4 2000r.

Review translated automatically

Reliable opinion

2024-06-22, 08:03

View original

Rafał

The seals fit suzuki gsx600f. Finally stopped leaking from the suspension and its operation improved significantly. I recommend

Review translated automatically

Reliable opinion

2017-04-22, 09:26

View original

Rafał

Rubber workmanship very well and aesthetically pleasing, all components conformed to the dimensions of the original without any problems.

Review translated automatically

Reliable opinion

2019-01-29, 16:31

View original

Dawid

I have a 2011 Honda Varadero xl 125. The spark plugs have super performance. After replacing them, the motorcycle fired up better. I recommend!

Review translated automatically

Reliable opinion

2024-05-07, 13:14

View original

dominik

The filter fits the motorcycle, a nice employee even contacted and inquired about the model along with the year to better match.

Review translated automatically

Reliable opinion

2024-09-11, 14:40

View original

Marcin

Very good quality workmanship fit perfectly to the lags 2 sets mounted on Moto and miles fly nothing leaks.

Review translated automatically

Reliable opinion

2024-01-02, 08:24

View original

Jakub

A filter like a filter. I put these in all my Moto's, older and newer. So far there have been no problems with them.

Review translated automatically

Reliable opinion

2023-06-15, 14:32

View original

Jarosław

The filter is very good quality, it installs without any problems. After driving 400km since replacement, I have not noticed any problems.

Review translated automatically

Reliable opinion

2020-09-05, 11:49

View original

Łukasz

Used on a Honda shadow 1100 everything fits and is ok, I recommend filters from this company good value for money

Review translated automatically

Reliable opinion

2023-09-15, 09:18

View original

Rafał

Quality ok. parts from gmoto.pl fit very well, everything I needed I found in one place. I recommend

Review translated automatically

Reliable opinion

2022-05-02, 11:20

View original

Mirosław

Honda SW t400 year 2010 very good filter, very good workmanship, fits my Honda It met my expectations

Review translated automatically

Reliable opinion