Motorcycle parts
Honda CBR 400 RR Gullarm 1990 - Page 2

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2017-07-15, 09:23

View original

Dawid

2000 Honda CBR 600F. The regulator works as expected + good price. I had previously tested a custom-made regulator, purchased at reg_mot.republika.pl, and unfortunately found that it drew current at a standstill, and was quite a bit larger than the standard regulator and required rearranging the components under the fairing. Tour-max regulator is the same size as the original, works perfectly. I am satisfied, I recommend it!

Review translated automatically

Reliable opinion

2021-02-02, 22:02

View original

Daniel

99r Honda VFR 800 FI RC46. Simple quick installation. Filter adapted for an ordinary ring wrench. Uses k&n products great look and performance. I recommend

Review translated automatically

Reliable opinion

2019-03-10, 10:47

View original

Mirosław

Kawasaki Z900. The filter is better made than the original. Very good ease of installation,I am 100% satisfied and recommend to everyone.

Review translated automatically

Reliable opinion

2019-03-15, 08:51

View original

Dominik

Honda varadero 125 XL. Replacement quick and easy. Candles of very good quality. The transaction went well. I recommend

Review translated automatically

Reliable opinion

2021-10-08, 12:10

View original

Artur

There is nothing to say about Hiflo and the quality of their products, so I usually choose their filters.

Review translated automatically

Reliable opinion

2022-03-31, 10:27

View original

Dariusz

Fitting filter for Kawasaki versys KLE 650 , the advantage of it is that it has a key cap .it is ok

Review translated automatically

Reliable opinion

2023-06-14, 02:35

View original

Mariusz

Installation: perfect fit to the frame holes (Honda CBR 600F4) Operation: charging at idle 13.4-13.7 V, maximum charging voltage 14.4-14.6 V (holds until cut-off, measured with a meter) The price is quite exorbitant, although the parameters reflect what it should be. Cheaper Chinese ones I'm afraid of, while here there is more confidence in the quality of the product.

Review translated automatically

Reliable opinion

2019-03-05, 18:49

View original

Tomek

Handa CB 500 1994 year 42 kW I opted for a vibration damping shift sprocket because of the product description and I am satisfied. The gear shifts (they are to a small degree perceptible but.) seem to be softer and the chain runs a little quieter. My riding style and handling of the unicycle is generally quiet so for the moment the sprocket passes the test

Review translated automatically

Reliable opinion

2021-06-29, 10:25

View original

Leszek

Honda XL 600 V Transalp. A filter like a filter, it's hard to judge it by eye. It screwed in easily and pleasantly. All indications are that it filters as God has commanded. Shouldn't there be an o-ring in the place where it is screwed onto the spigot protruding from the block? I can't hide the fact that I would be happy to win four hundred bucks because I need a clutch and cash is tight.

Review translated automatically

Reliable opinion

2024-05-03, 05:47

View original

Staniaław

Battery of very good quality, moto fires up from a shot. Well matched for the model, just in my case a hornet. Easy installation, included gel and clear instructions. As for the first battery replacement, the process went smoothly and without problems. Yuasa better protects a possible leak than the earlier zipp. I recommend

Review translated automatically

Reliable opinion

2020-05-03, 00:23

View original

Maciej

Wsk 125 The frame is nice, you can't expect more from a plastic metallized one. It fits my wsk-i nicely. The only big minus is that it did not fit completely in the holes - I had to widen the holes with a drill both at the top and bottom. Other than that, installation was easy. I recommend the product for those who don't mind making up holes.

Review translated automatically

Reliable opinion

2020-03-30, 20:41

View original

Michał

Sealers without complaint. In a rigid and secure package a set of sealers and covers for two leaguers. Assembly trivially easy (for those who like and have an idea of DIY and small repairs). The fit is perfect. So far zero problem and the lags work perfectly in combination with Motul 10W oil.

Review translated automatically

Reliable opinion

2023-05-24, 21:04

View original

Dariusz

very good product,easy to install,app to download,connects to your phone via blue tooth and you have everything on the screen of your phone,like charging current,battery condition,monitoring its performance and so on,very useful thing,highly recommend in good conscience

Review translated automatically

Reliable opinion

2021-05-08, 07:38

View original

Andrzej

Plastic license plate frame looks like a good chrome material I changed the plate because I became the owner of a Suzuki Intruder VL 125 2000 year all in all. Looks super material fine that's why the price very low ugly comes longer.

Review translated automatically

Reliable opinion

2020-07-08, 19:23

View original

Waldemar

My machine is an 86 Honda Shadow VT 1100 . Purchased parts were not dedicated for this vintage , so as a novice user I bought blind and surprisingly they fit . Installation was no problem and the material and workmanship flawless . G Moto and product on pistket . LWG .

Review translated automatically

Reliable opinion

2021-08-08, 10:10

View original

Klaudiusz

Honda CBR 1100XX Super Blackbird from 1997, the replacement went without a problem, the bearings and seals fit. After replacement, you can feel a big improvement and much lighter handling. The old bearings were worn and jumped into the "point" when straightening the steering wheel, now there is no such thing.

Review translated automatically

Reliable opinion

2017-05-15, 22:44

View original

Maciej

Patient Honda CB600F Hornet, vintage 2001, non-functioning fan switch. What can I say, a top-notch product. After replacement, the fan spins and works at its best. This radiator fan switch is a great product, I would recommend it to anyone

Review translated automatically

Reliable opinion

2016-03-18, 21:30

View original

Rafał

Honda Shadow VT 750 Black Spirit RC48 2003. The filter compared to the previous one I had installed has a nut, which makes it much easier to install /remove the filter, in the absence of a special key for installation. Definitely a plus.

Review translated automatically

Reliable opinion

2021-03-31, 10:03

View original

Dominik

The seals look decently made. We'll see how with their durability. I'll admit that there were problems with installation and it took some time, but they are finally sitting in place. Now only field tests.

Review translated automatically

Reliable opinion

2017-11-17, 07:02

View original

Jakub

We fitted the bearings to a 2004 Honda Hornet pc36. The installation went smoothly and the bearings seem indestructible ;) Well, but this is Mc International after all, the top shelf among parts for Japanese ;)

Review translated automatically

Reliable opinion

2019-06-17, 07:58

View original

Damian

In the category of quality/price very nice frame. Strong plastic imitating chrome. Aesthetics at a high level. Lightweight and durable And the license plate enters on contact ( for me a plus because there is no slack). I recommend

Review translated automatically

Reliable opinion

2019-02-17, 20:22

View original

Jerzy

I own a Suzuki Intruder 124ccm.I purchased a battery for my machine and I am super satisfied,I received what I ordered,quickly and efficiently.Yuasa YTX7L-BS battery super.I recommend shopping with this company.

Review translated automatically

Reliable opinion

2023-05-29, 13:07

View original

Mariusz

When it comes to oil filtration in our motorcycles, K&N is simply in a class of its own. I've been using them forever and although it's just a filter I can't imagine another one in my machine. I recommend.

Review translated automatically

Reliable opinion

2022-01-18, 20:35

View original

Sławomir

Filter hiflo 303 RC, standard height, throughput to be evaluated, as I wear it out I'll see if the only difference is the key cap on the body, although at first glance it looks similar. We'll see.

Review translated automatically

Reliable opinion

2021-01-24, 16:53

View original

Bogdan

I own a motorcycle honda CBR 1000F, vintage 1966, capacity 1000 cm. This is another filter from this manufacturer that I bought, and I have never had any problems with them have always served their purpose.

Review translated automatically

Reliable opinion

2022-01-11, 15:35

View original

Wojciech

XL 600VA 1987 Oil easy to use does not require instructions. I recommend this product. Very good quality product for its price. Quick delivery hassle-free service. I recommend

Review translated automatically

Reliable opinion

2020-03-30, 20:44

View original

Michał

The protections, compared to the old ones, are slightly wider, more rigid and more "expandable", which makes them fit perfectly into the groove in the lade blocking the sealers.

Review translated automatically

Reliable opinion

2017-09-04, 10:25

View original

Mariusz

frame very nice, put on jawa ts 350 looks very good on this motorcycle, installation also very pleasant immediately changes the name of the motorcycle adds better charm

Review translated automatically

Reliable opinion

2019-01-14, 11:45

View original

Łukasz

Hello, The filter I purchased meets my expectations. Easier to install than standard filters. I am very satisfied and recommend, Greetings

Review translated automatically

Reliable opinion

2024-09-25, 05:27

View original

Filip

Very good solution for those who want to replace the license plate frame with a new one. The price is very affordable. The quality of workmanship is also flawless. I can recommend

Review translated automatically

Reliable opinion

2020-04-06, 10:07

View original

Mariusz

The battery and electrolyte seems to be original - solid workmanship and parameters as listed in the description - all packed in a nice box. I recommend!

Review translated automatically

Reliable opinion

2018-03-05, 18:27

View original

MARCIN

Hello, I bought this filter for oil change in my motorcycle i.e. 2006 Yamaha Stratoliner 1900. I have been using this product for about 5 years and am satisfied with it.

Review translated automatically

Reliable opinion

2024-09-24, 06:41

View original

Tomasz

The filter performs its function perfectly, after pouring off the old oil you can not see any flecks, etc. Thanks to the flexible gasket, I tighten it by hand and nothing leaks.

Review translated automatically

Reliable opinion

2021-12-12, 20:14

View original

Kordian

I always buy filters from HIflo and this time, too, everything fits until nice. I recommend to trust this brand as much as possible. Gmoto as usual at a high level. XJ600

Review translated automatically

Reliable opinion

2024-05-03, 07:48

View original

Bogusław

Great sealers, they fit nice and tight even though the lag was polished, so far only about 100km after replacement but no drop on the lag, I recommend

Review translated automatically

Reliable opinion

2019-08-26, 12:15

View original

Sławomir

I own a Honda NT650V Deauville. The seals seem solid because of the 2 spring rings. The previous ones only had one such ring.

Review translated automatically

Reliable opinion

2020-04-26, 21:15

View original

Marcin

Fits perfectly on my old venerable XJtek, from 96. No problems with threads or leakage from under the filter gasket. I highly recommend the product.

Review translated automatically

Reliable opinion

2023-05-24, 07:13

View original

Remi

Sealers well made, there was no problem with the installation which indicates well-behaved parameters. Tight, oil no longer leaks.

Review translated automatically

Reliable opinion

2020-02-11, 17:50

View original

Piotr

Sealers very good quality not some cheap plastic. There are 2 springs on each sealer. Fast shipping. Recommended.

Review translated automatically

Reliable opinion