Forgot password
Order status
Free delivery from 150 euro
Motorcycle parts
Honda CR 80 R 1993 - Page 8
Manufacturer
Price
Sort
Options +4 
€22.36
Lowest price from 30 days before discount: €23.54
TRW Lucas MCB 575 SI brake pads (2 pieces).
(2) 
Options +4 €15.62
Lowest price from 30 days before discount: €16.44
TRW Lucas MCB 575 EC brake pads (2 pieces).
(2) 
Options +4 €24.61
Lowest price from 30 days before discount: €25.90
TRW Lucas MCB 575 RSI brake pads (2 pieces).
(2) 
Options +4 €20.79
Lowest price from 30 days before discount: €21.88
TRW Lucas MCB 575 brake pads (2 pieces).
(2) 
Options +3 
€23.26
Lowest price from 30 days before discount: €24.48
TRW Lucas MCB 561 SI brake pads (2 pieces).
Options +3 €15.62
Lowest price from 30 days before discount: €16.44
TRW Lucas MCB 561 EC brake pads (2 pieces).
Options +2 
€49.07
Lowest price from 30 days before discount: €54.53
DID 428 NZ 114 G&B open drive chain with clasp gold
(8) 
Options +4 
€36.15
Lowest price from 30 days before discount: €40.17
DID 420 NZ3 114 G&B open drive chain with clasp gold
(81) 
€22.43
Lowest price from 30 days before discount: €23.61
Top-End Engine Gasket Kit Athena Race series - R2106-085
€22.14
Lowest price from 30 days before discount: €23.30
A set of TRW Lucas MES 331-4 metal clutch discs. - MES331-4
(5) 
€21.01
Lowest price from 30 days before discount: €22.12
Top-End Athena engine gasket set - P400210600085
Options +3 €5.64
Lowest price from 30 days before discount: €5.94
JT front sprocket JTF1256.15, 15z size 420
(1) 
€7.39
Lowest price from 30 days before discount: €7.78
Athena front suspension seal set 36x48x8/9.5 - P40FORK455035
(5) 
€16.47
Lowest price from 30 days before discount: €17.34
HifloFiltro sponge air filter HFF1011 - HFF1011
from 9
Browse by manufacturer
Products reviews
I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.
Review translated automatically
Reliable opinion
Hello, I purchased a DID product for Mrf 140 RC I ordered 114 links I had to shorten 6 links in my opinion it was difficult to break but after a few rides of 2-3 I was slightly disappointed because the chain wore out, that is, the gold color peeled off and the usual gray showed up, so far I do not know how to stretch it, but after these rides it did not stretch out too much so what's good about + -GOOD WORKMANSHIP -LIKEABLE - SOLID what's in the - - HE STRETCHED A LITTLE, BUT I THINK IT WILL STABILIZE - THE GOLD COLOR CAME OFF A BIT
Review translated automatically
Reliable opinion
Honda Africa XRV 750 - 1999. I bought 12 pieces. This mounting rubber is found in several places on the motorcycle(the mount of the skull rack, oil cooler, plastic handles, etc.). It looks like the original, the rubber is flexible, you can bend it with two fingers with a stronger squeeze and it looks solid. Only the course of time can verify whether it is as solid. Dimensions: Hole diameter(nominal): 10mm Width of the entire rubber: 22mm Groove depth: 8mm
Review translated automatically
Reliable opinion
I have a 2003 Honda XR 125 L. I was replacing the clutch now for the second time, the discs worked fine, they really lasted with me for about 10,000km. Now I installed them for the second time and everything went without the slightest problem. (Psst. Make sure that for your motorcycle you don't need any specialized key in the motorcycle manual and check how many discs are needed for your motorcycle, in my honda - 5)
Review translated automatically
Reliable opinion
I have a 2003 Honda XR 125 L. I am replacing the clutch for the second time (after 10,000km) with hard off-road and city riding. Metal discs passed the test that's why I buy them for the second time. Installation without a problem, but remember the specialized keys for your motorcycle, and the clutch cover gasket.
Review translated automatically
Reliable opinion
I was looking for a replacement for a 1998 Triumph Thunderbird 900, everything fits like a glove, installation without the slightest problems, service in the store as usual without reservation.
Review translated automatically
Reliable opinion
Good Piston at least so far worked once on a sand pile, used to test and pull, fits Honda cr with 46mm bore i.e. if the bonnet says 79cm³
Review translated automatically
Reliable opinion
Bmw R 1100 RT 2000 year, I purchased a set of consumables. Very friendly, professional service and advice. Competitive prices. They respond to emails. You are kept informed about the shipping status. This was my 3rd contact with the company. I recommend, I will certainly use again more than once. Regards, Tycjan
Review translated automatically
Reliable opinion
Honda XL125 Varadero. After replacement, the play in the suspension of the rocker arm was erased and the comfort of the ride increased. The part fit very well and very good quality. The store works accurately, very good contact, good prices-I recommend.
Review translated automatically
Reliable opinion
Suzuki DR 125,a friend's motorcycle, ALL BALLS seals are not my favorite company, they are often difficult to install, it is often necessary to heat the shin to get the sealer to pop into place.
Review translated automatically
Reliable opinion
This mounting rubber is a great replacement for the rubbers found on the Honda CBR 600, but they are slightly smaller than the original (I personally didn't mind the installation)
Review translated automatically
Reliable opinion
Fits new tubes without a hitch, and after several km on normal roads, no leaks to report. We'll have to wait and see how the rubber ages over time.
Review translated automatically
Reliable opinion
The motorcycle is a honda transalp 600 1996r.The element fit perfectly without any reservations thanks to good workmanship and fit the repair went quickly and efficiently.Regards
Review translated automatically
Reliable opinion
Excellent product. It fit properly in the caliper and I no longer have any leakage from the wear and tear of the previous one. Tourmax quality comparable to the factory ones.
Review translated automatically
Reliable opinion
Sealers fit varadero 125 2002, workmanship ok, trouble-free installation. So far the suspension works ok, we'll see how long they last.
Review translated automatically
Reliable opinion
Recommended. The product is consistent with the photo. Carefully packed in foil, you can see that no one rummaged at it. Very good quality for the price.
Review translated automatically
Reliable opinion
Goods very well packaged and protected in a clear box, you can see what you are buying made solidly and with good materials. Recommended.
Review translated automatically
Reliable opinion
Fork clamp rings for my MZ MUZ RT 125 Classic. Fit super tight in the bars, seal well. I can't write about long-term experience yet.
Review translated automatically
Reliable opinion
Good product, well fitted, only delivered in sets of four when there were three on disassembly, so the doubt lingered for several minutes.
Review translated automatically
Reliable opinion
I believe that the sealers are very durable and will last for at least 3 years with confidence. The company tested and recommended, they do not pass
Review translated automatically
Reliable opinion
The kit fits KMX 125 without any problems. 74zł is the cheapest option I found. I recommend. The motorcycle again goes where I want it to go.
Review translated automatically
Reliable opinion
Good product delivered quickly. I searched for a while to avoid spending so much and found what I was looking for at GMOTO. That's how it should be.
Review translated automatically
Reliable opinion
All ok, well fitted already a few thousand km behind me and all well sealed, nothing sweats Honda CBR 600 F4 2000r.
Review translated automatically
Reliable opinion
BMW R1150 RT 2002 YEAR, the replacement went quickly and without any difficulties, gaskets very good according to my expectations
Review translated automatically
Reliable opinion
Delivered as ordered. Everything in order. I would order from GMoto again. It is a reliable supplier.
Review translated automatically
Reliable opinion
Good product - the aphrodite stopped "buzzing" at higher speeds. I also have the impression that it got a bigger kick ;)
Review translated automatically
Reliable opinion
Honda Transalp XL 600 1999. Rubber installed fits it is not orginal but can be goes in its place .
Review translated automatically
Reliable opinion
Sealers are made of a good rubber material by which it seals well the lagi nothing leaks. I recommend.
Review translated automatically
Reliable opinion
Arbor as much as ok, fits everything without any problem is durable does not wear out quickly good quality
Review translated automatically
Reliable opinion
Thank you for the fast delivery, the plates are great and functional. I order as needed and so far so good.
Review translated automatically
Reliable opinion
Recommended. The product is consistent with the photo. Carefully packed in foil, you can see that no one rummaged at it.
Review translated automatically
Reliable opinion
Seal protection solidly made, I can say that even better than the originals. I recommend.
Review translated automatically
Reliable opinion
The rubbers fit and hold everything in place. Quality of fit and workmanship without any reservations.
Review translated automatically
Reliable opinion
Good quality fast delivery, fits without any problems, recommend !!!!!!!!!!!!! Honda Hornet cb 600 pc 36
Review translated automatically
Reliable opinion
Ktm 80 rlw very good quality product installation was done without any problems and engine operation has improved
Review translated automatically
Reliable opinion
It fits perfectly on a 2003 Suzuki RM 125. I installed and can continue to ride off-road. Thanks a lot :)
Review translated automatically
Reliable opinion
Great product as described. Everything as expected. Fast delivery.
Review translated automatically
Reliable opinion
Honda NSR 125 1997. Very useful, just a little expensive.
Review translated automatically
Reliable opinion
Ok.quality-price acceptable. I am satisfied. I recommend
Review translated automatically
Reliable opinion
Other models of
- Honda CR 80 RB 2003
- Honda CR 80 RB 2004
- Honda CR 80 RB 2005
- Honda CR 80 RB 2006
- Honda CR 80 RB 2007
- Honda CR 80 R [19 cali] 1985
- Honda CR 80 R [19 cali] 1986
- Honda CR 80 R 1980
- Honda CR 80 R 1981
- Honda CR 80 R 1982
- Honda CR 80 R 1983
- Honda CR 80 R 1984
- Honda CR 80 R 1985
- Honda CR 80 R 1986
- Honda CR 80 R 1987
- Honda CR 80 R 1988
- Honda CR 80 R 1989
- Honda CR 80 R 1990
- Honda CR 80 R 1991
- Honda CR 80 R 1992
- Honda CR 80 R 1994
- Honda CR 80 R 1995
- Honda CR 80 RB [19 cali] 1996
- Honda CR 80 RB [19 cali] 1997
- Honda CR 80 RB [19 cali] 1998
- Honda CR 80 RB [19 cali] 1999
- Honda CR 80 RB [19 cali] 2000
- Honda CR 80 RB [19 cali] 2001
- Honda CR 80 RB [19 cali] 2002
- Honda CR 80 R [17/14 cali] 1980
- Honda CR 80 R [17/14 cali] 1996
- Honda CR 80 R [17/14 cali] 1999
- Honda CR 80 R [17/14 cali] 1998
- Honda CR 80 R [17/14 cali] 1997
- Honda CR 80 R [17/14 cali] 2000
- Honda CR 80 R [17/14 cali] 2001
- Honda CR 80 R [17/14 cali] 2002