Motorcycle parts
Honda FJS 600 Silver Wing - Page 4

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2018-11-12, 15:59

View original

Krzysztof

Honda Africa Twin XRV 750 1999. The piston fits the calipers on older models, the pistons for my motorcycle are 3mm shorter. I ordered the set with the idea of shortening it. The material turned out to be soft compared to the original(this does not prove its strength, therefore the rating of 3 from the quality), cutting 3mm on the lathe did not overheat the pad and after protecting it on the turning side with an appropriate specific will ensure that it will not lose its anti-corrosion properties. A perfect replacement for the twice more expensive original. The width agrees, the quality of the seals seems to be OK, after installation it does its job - I recommend.

Review translated automatically

Reliable opinion

2018-11-01, 20:28

View original

Krzysztof

Honda Africa XRV 750 - 1999. I bought 12 pieces. This mounting rubber is found in several places on the motorcycle(the mount of the skull rack, oil cooler, plastic handles, etc.). It looks like the original, the rubber is flexible, you can bend it with two fingers with a stronger squeeze and it looks solid. Only the course of time can verify whether it is as solid. Dimensions: Hole diameter(nominal): 10mm Width of the entire rubber: 22mm Groove depth: 8mm

Review translated automatically

Reliable opinion

2025-09-22, 15:11

View original

Jordi

Honda Cb500 PC26 - 1994 Includes the parts needed to repair the front brake master cylinder. These are not the original Honda parts, but they are good quality and fit the brake pump perfectly.

Review translated automatically

Reliable opinion

2020-11-22, 22:44

View original

Piotr

Filter installed on a 2004 Varadero 1000. Filter in a cardboard box additionally protected by a film. Filter gasket moistened with some agent to prevent damage during screwing.

Review translated automatically

Reliable opinion

2019-01-12, 09:03

View original

Andrzej

Honda Cbf 500 2007. Sealers very good quality . Hassle-free installation. You can see at a glance that it is an original product of Athena.Oil burning I have already.I recommend.

Review translated automatically

Reliable opinion

2024-09-20, 12:07

View original

Aurélien

Purchased to completely rebuild my Nissin 11mm master cylinder. The kit fits perfectly. My master cylinder is back for life.

Review translated automatically

Reliable opinion

2019-03-15, 08:51

View original

Dominik

Honda varadero 125 XL. Replacement quick and easy. Candles of very good quality. The transaction went well. I recommend

Review translated automatically

Reliable opinion

2024-09-20, 12:04

View original

Aurélien

Used for a complete rebuild of my caliper, the piston is the same as the original. I recommend

Review translated automatically

Reliable opinion

2025-06-24, 10:53

View original

Ahmed

I ride a Yamaha MT-03 built in 2016 and after some research I deliberately chose the HifloFiltro HF204 oil filter - and I am absolutely satisfied! As soon as you unpack it, you notice that the filter makes a high-quality impression, clean workmanship, solid materials and everything looks well thought out. Installation went smoothly - it fits perfectly on my MT-03 without any fiddling. I had previously fitted the original filter from Yamaha and I don't see any difference in terms of quality, on the contrary: the HifloFiltro looks at least as good, if not better. What I particularly like is that the filter is TÜV-approved and complies with OEM specifications, so you can be sure that it is absolutely reliable in terms of filter performance. After the oil change with this filter (in combination with a high-quality 10W-40 oil), the engine ran smoothly and quietly again straight away. No leaks, not a drop of oil - everything was clean and tight. Even after several hundred kilometers, everything is as it was on the first day. Since then, I have the feeling that the engine runs a little smoother - whether this is purely subjective or actually due to the combination of fresh oil and this high-quality filter remains to be seen. But the driving experience is great! What's more, the price is unbeatable. Compared to the original part, the HF204 is a very inexpensive but absolutely equivalent (if not better) replacement in terms of quality. For anyone who maintains their MT-03 themselves and values reliable parts, this is a clear recommendation. I will definitely use the HifloFiltro HF204 again for my next oil change. Top quality, easy installation, good fit and a fair price-performance ratio - it doesn't get any better than this!

Review translated automatically

Reliable opinion

2022-09-28, 18:40

View original

Stanisław

Honda NTV 650 Revere 97r. Kit well made, good quality parts, easy installation good fit. Replaces the original parts well, the pump works flawlessly. I would like to add that the kit was purchased on the recommendation of a Honda service employee because the original repair kit costs almost 4 times as much, and this one does its job 100%. I sincerely recommend.

Review translated automatically

Reliable opinion

2020-05-03, 00:23

View original

Maciej

Wsk 125 The frame is nice, you can't expect more from a plastic metallized one. It fits my wsk-i nicely. The only big minus is that it did not fit completely in the holes - I had to widen the holes with a drill both at the top and bottom. Other than that, installation was easy. I recommend the product for those who don't mind making up holes.

Review translated automatically

Reliable opinion

2025-08-03, 20:59

View original

Aksel

Have used these gaskets for the valve cover screws and they do exactly what they are supposed to. They seal tight, keep oil in and seem like a definite improvement over worn original gaskets. Installation was easy and the material feels both resilient and durable. No signs of oil sweat after installation - completely satisfied!

Review translated automatically

Reliable opinion

2021-05-08, 07:38

View original

Andrzej

Plastic license plate frame looks like a good chrome material I changed the plate because I became the owner of a Suzuki Intruder VL 125 2000 year all in all. Looks super material fine that's why the price very low ugly comes longer.

Review translated automatically

Reliable opinion

2017-07-11, 09:59

View original

Mariusz

I am a happy owner of a yamaha yzf 125r in which I recently noticed oil loss , I replaced the valve seals which I ordered from gmoto and I am very satisfied , solidly made . Easy to install and fit to my 2010r modelj recommend to everyone.

Review translated automatically

Reliable opinion

2017-07-11, 09:59

View original

Mariusz

I am a happy owner of a yamaha yzf 125r in which I recently noticed oil loss , I replaced the valve seals which I ordered from gmoto and I am very satisfied , solidly made . Easy to install and fit to my 2010r model I recommend to everyone.

Review translated automatically

Reliable opinion

2025-03-13, 07:45

View original

Miroslav

I normally use these oil filters and do not foresee any complications due to the tightness of the installation - replacement. So far I haven't done an oil change yet. I expect complete satisfaction following the last positive experience

Review translated automatically

Reliable opinion

2024-09-20, 06:30

View original

Alexandros

Good morning, I was looking everywhere for this particular replacement, but I only found it in this store. I am very happy with the quality of the product in relation to the price. It's worth it and more.

Review translated automatically

Reliable opinion

2021-02-15, 09:25

View original

Wiktor

Very good quality product. Easy installation, durable material. Everything is of the highest level. I am not a writer to write fairy tales in the opinion of 100 characters, so I invite you to buy. I heartily recommend.

Review translated automatically

Reliable opinion

2019-06-17, 07:58

View original

Damian

In the category of quality/price very nice frame. Strong plastic imitating chrome. Aesthetics at a high level. Lightweight and durable And the license plate enters on contact ( for me a plus because there is no slack). I recommend

Review translated automatically

Reliable opinion

2020-02-02, 11:46

View original

Bartosz

Triumph Street Triple 765 I have been using HIFLOFILTRO filters for years. In the standard version they do their job perfectly. You can the racing version, but for daily riding there is no need for it.

Review translated automatically

Reliable opinion

2024-04-13, 07:28

View original

Mariusz

Filters oil, flows on. No problems with pressure or leaking. It looks good on the CBR 600 F4i - by the color you just can't even see it between the exhaust manifolds ;)

Review translated automatically

Reliable opinion

2019-12-27, 13:32

View original

Mariusz

Honda Shadow VT 600 1994. The kit includes all the gaskets that need to be replaced when reconditioning the brake caliper, plus grease for the piston. Everything fit as in the original.

Review translated automatically

Reliable opinion

2023-09-11, 20:14

View original

sara

This mounting rubber is a great replacement for the rubbers found on the Honda CBR 600, but they are slightly smaller than the original (I personally didn't mind the installation)

Review translated automatically

Reliable opinion

2021-03-20, 11:29

View original

Bartosz

The motorcycle is a Honda Transalp XL 600 The piston holds the dimension perfectly in every plane. The only difference is the different shape of the bottom of the piston, but this does not seem to affect the operation.

Review translated automatically

Reliable opinion

2017-09-04, 10:25

View original

Mariusz

frame very nice, put on jawa ts 350 looks very good on this motorcycle, installation also very pleasant immediately changes the name of the motorcycle adds better charm

Review translated automatically

Reliable opinion

2021-02-13, 13:15

View original

Krzysztof

I own a 2015 Honda Goldwing 1800, the oils as well as any products I purchase are always first quality. I recommend to everyone. Installation without any problems.

Review translated automatically

Reliable opinion

2023-06-09, 19:22

View original

Marek

HIFLOFILTRO filter is a very good solution for any motorcycle. And straightforwardly perfect. I used in each of my motorcycle at each mileage. I heartily recommend.

Review translated automatically

Reliable opinion

2024-09-25, 05:27

View original

Filip

Very good solution for those who want to replace the license plate frame with a new one. The price is very affordable. The quality of workmanship is also flawless. I can recommend

Review translated automatically

Reliable opinion

2019-06-10, 20:27

View original

Wojciech

Fits perfectly, should be added to the oil refinisher, the cost is pennies and most often the protection is already affected by corrosion and suitable for replacement

Review translated automatically

Reliable opinion

2024-11-08, 06:13

View original

Milan

Good quality, good price, fast delivery. Very few sellers for this product and none at this price. Maximum satisfaction. I will order again. This time turn signals.

Review translated automatically

Reliable opinion

2020-05-13, 06:44

View original

Damian

Honda VTX 1300 2006. The master cylinder was reconditioned with the kit purchased. Fast, efficient. High quality goods. The pump works like new.

Review translated automatically

Reliable opinion

2025-04-13, 11:27

View original

NIKOS

Excellent product. It fit properly in the caliper and I no longer have any leakage from the wear and tear of the previous one. Tourmax quality comparable to the factory ones.

Review translated automatically

Reliable opinion

2024-07-05, 06:46

View original

Krzysztof

Great quality replacement, the previous protection totally corroded, I hope this will live a little. I replaced it on a DR 650 SE vintage 1996

Review translated automatically

Reliable opinion

2020-08-21, 06:39

View original

Michał

The description does not match the goods I received. The package marked with a sticker (chrome filter) but in the package was a regular black filter.

Review translated automatically

Reliable opinion

2020-06-01, 17:53

View original

mariusz

yamaha diversion 600 2002 element purchased really good quality,without any problems installed in the shin of the front suspension recommend kind regards lwg

Review translated automatically

Reliable opinion

2020-06-08, 10:06

View original

Łukasz

I am satisfied everything efficiently and according to what I ordered. The ordered goods meet my expectations. I positively evaluate this store.

Review translated automatically

Reliable opinion

2025-09-18, 10:04

View original

ΔΗΜΗΤΡΗΣ

It has nickel finish but its plastic, the article says metallic but thats wrong, if you want it for enduro bike or adv its not metallic

Review translated automatically

Reliable opinion

2016-05-27, 06:41

View original

Andrzej

-Kawasaki Vulcan EN 500A 1991. -after installation, the tightness of the exhaust system improved -It was definitely worth to buy the above mentioned product.

Review translated automatically

Reliable opinion

2021-05-18, 18:12

View original

Krzysztof

Honda CBR F3 600 PC31 year of manufacture 1995 quick disassembly as well as installation of bearings I recommend and greet you not the first and not the last purchase from you.

Review translated automatically

Reliable opinion