Motorcycle parts
Honda NC 750 J NM4 Vultus DCT ABS 2015 - Page 3

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2018-11-12, 15:59

View original

Krzysztof

Honda Africa Twin XRV 750 1999. The piston fits the calipers on older models, the pistons for my motorcycle are 3mm shorter. I ordered the set with the idea of shortening it. The material turned out to be soft compared to the original(this does not prove its strength, therefore the rating of 3 from the quality), cutting 3mm on the lathe did not overheat the pad and after protecting it on the turning side with an appropriate specific will ensure that it will not lose its anti-corrosion properties. A perfect replacement for the twice more expensive original. The width agrees, the quality of the seals seems to be OK, after installation it does its job - I recommend.

Review translated automatically

Reliable opinion

2020-11-22, 22:44

View original

Piotr

Filter installed on a 2004 Varadero 1000. Filter in a cardboard box additionally protected by a film. Filter gasket moistened with some agent to prevent damage during screwing.

Review translated automatically

Reliable opinion

2022-04-08, 08:24

View original

Arkadiusz

Honda Shadow 125 ,year 2000 chain fits perfectly. Everything in order,I highly recommend Gmoto.pl

Review translated automatically

Reliable opinion

2024-09-20, 12:04

View original

Aurélien

Used for a complete rebuild of my caliper, the piston is the same as the original. I recommend

Review translated automatically

Reliable opinion

2025-06-24, 10:53

View original

Ahmed

I ride a Yamaha MT-03 built in 2016 and after some research I deliberately chose the HifloFiltro HF204 oil filter - and I am absolutely satisfied! As soon as you unpack it, you notice that the filter makes a high-quality impression, clean workmanship, solid materials and everything looks well thought out. Installation went smoothly - it fits perfectly on my MT-03 without any fiddling. I had previously fitted the original filter from Yamaha and I don't see any difference in terms of quality, on the contrary: the HifloFiltro looks at least as good, if not better. What I particularly like is that the filter is TÜV-approved and complies with OEM specifications, so you can be sure that it is absolutely reliable in terms of filter performance. After the oil change with this filter (in combination with a high-quality 10W-40 oil), the engine ran smoothly and quietly again straight away. No leaks, not a drop of oil - everything was clean and tight. Even after several hundred kilometers, everything is as it was on the first day. Since then, I have the feeling that the engine runs a little smoother - whether this is purely subjective or actually due to the combination of fresh oil and this high-quality filter remains to be seen. But the driving experience is great! What's more, the price is unbeatable. Compared to the original part, the HF204 is a very inexpensive but absolutely equivalent (if not better) replacement in terms of quality. For anyone who maintains their MT-03 themselves and values reliable parts, this is a clear recommendation. I will definitely use the HifloFiltro HF204 again for my next oil change. Top quality, easy installation, good fit and a fair price-performance ratio - it doesn't get any better than this!

Review translated automatically

Reliable opinion

2017-04-07, 10:56

View original

Bartłomiej

DID chains, as you know, have an excellent reputation among motorcyclists. Not without reason. Excellent quality and durability. This model perfectly supports motorcycles with power reaching well over 100 hp. Its durability is perfectly evidenced by the fact that I had to get a new, better cupping machine to install it. The current one gave up. The chain is extremely durable. I recommend it to everyone!

Review translated automatically

Reliable opinion

2025-08-03, 20:59

View original

Aksel

Have used these gaskets for the valve cover screws and they do exactly what they are supposed to. They seal tight, keep oil in and seem like a definite improvement over worn original gaskets. Installation was easy and the material feels both resilient and durable. No signs of oil sweat after installation - completely satisfied!

Review translated automatically

Reliable opinion

2022-02-07, 10:42

View original

KONRAD

Hello, I bought this kit to stock to keep on the shelf for my Benelli TNT 1130 Gaskets very good company Athena I know and recommend. GMOTO SERVICES ALSO RECOMMEND always professional and without lime well packed and on time recommends and regards

Review translated automatically

Reliable opinion

2024-12-25, 08:04

View original

Joaquin

I ordered the battery for the bike I have, a KTM 1290 and I had to have the size for the hole, they have gel and lithium also, but I decided for one as the origin. They have very good prices, it didn't take long to arrive. Everything is great.

Review translated automatically

Reliable opinion

2025-03-13, 07:45

View original

Miroslav

I normally use these oil filters and do not foresee any complications due to the tightness of the installation - replacement. So far I haven't done an oil change yet. I expect complete satisfaction following the last positive experience

Review translated automatically

Reliable opinion

2021-02-15, 09:25

View original

Wiktor

Very good quality product. Easy installation, durable material. Everything is of the highest level. I am not a writer to write fairy tales in the opinion of 100 characters, so I invite you to buy. I heartily recommend.

Review translated automatically

Reliable opinion

2017-11-17, 07:02

View original

Jakub

We fitted the bearings to a 2004 Honda Hornet pc36. The installation went smoothly and the bearings seem indestructible ;) Well, but this is Mc International after all, the top shelf among parts for Japanese ;)

Review translated automatically

Reliable opinion

2017-10-22, 08:45

View original

Przemysław

Honda shadow 125. chain is ideal, quick installation, noticeable improvement in motorcycle performance, bdb price lowest on the market. It is a good alternative to expensive oring chains. Recommended.

Review translated automatically

Reliable opinion

2020-02-02, 11:46

View original

Bartosz

Triumph Street Triple 765 I have been using HIFLOFILTRO filters for years. In the standard version they do their job perfectly. You can the racing version, but for daily riding there is no need for it.

Review translated automatically

Reliable opinion

2024-04-13, 07:28

View original

Mariusz

Filters oil, flows on. No problems with pressure or leaking. It looks good on the CBR 600 F4i - by the color you just can't even see it between the exhaust manifolds ;)

Review translated automatically

Reliable opinion

2020-03-30, 20:44

View original

Michał

The protections, compared to the old ones, are slightly wider, more rigid and more "expandable", which makes them fit perfectly into the groove in the lade blocking the sealers.

Review translated automatically

Reliable opinion

2020-05-25, 08:45

View original

Jacek

Honda cbr 1100 xx, bearings for the wheel work great. Quality and fit ok. protection from water and dirt is much better than in the previously worn. I recommend.

Review translated automatically

Reliable opinion

2021-03-20, 11:29

View original

Bartosz

The motorcycle is a Honda Transalp XL 600 The piston holds the dimension perfectly in every plane. The only difference is the different shape of the bottom of the piston, but this does not seem to affect the operation.

Review translated automatically

Reliable opinion

2020-11-17, 12:27

View original

Mateusz

As it is Athena seals are doing a cool job, 0 leaks so far, every moto of mine so far has just had Athena seals/rings and it has always been git.

Review translated automatically

Reliable opinion

2021-02-13, 13:15

View original

Krzysztof

I own a 2015 Honda Goldwing 1800, the oils as well as any products I purchase are always first quality. I recommend to everyone. Installation without any problems.

Review translated automatically

Reliable opinion

2023-06-09, 19:22

View original

Marek

HIFLOFILTRO filter is a very good solution for any motorcycle. And straightforwardly perfect. I used in each of my motorcycle at each mileage. I heartily recommend.

Review translated automatically

Reliable opinion

2019-04-27, 15:09

View original

Tomasz

Honda Vfr 750 rc 24 from 1987. The fit of the parts is very good making it a pleasure to assemble the exhaust system. It met my expectations as much as possible.

Review translated automatically

Reliable opinion

2025-04-30, 17:05

View original

Thomas

Bought to replace the original honda bearings, very good quality, fitted just right for the Hornet, very good price. Fast shipping, I recommend.

Review translated automatically

Reliable opinion

2025-04-13, 11:27

View original

NIKOS

Excellent product. It fit properly in the caliper and I no longer have any leakage from the wear and tear of the previous one. Tourmax quality comparable to the factory ones.

Review translated automatically

Reliable opinion

2020-08-21, 06:39

View original

Michał

The description does not match the goods I received. The package marked with a sticker (chrome filter) but in the package was a regular black filter.

Review translated automatically

Reliable opinion

2025-03-03, 10:37

View original

Juan

All correct and within the delivery time I think quality. Price is quite good. I would order again if I need a replacement. Thank you

Review translated automatically

Reliable opinion

2021-04-06, 09:16

View original

Bartłomiej

2014 Honda CRF 250 M Worn with oil to make it go in easier. They fit well, the suspension does not leak. At the next change I will also choose them.

Review translated automatically

Reliable opinion

2020-06-08, 10:06

View original

Łukasz

I am satisfied everything efficiently and according to what I ordered. The ordered goods meet my expectations. I positively evaluate this store.

Review translated automatically

Reliable opinion

2024-05-21, 20:40

View original

Mariusz

The sealer seems to be of good quality, I think it will serve well. It fits perfectly soon I will check it in the course of work.

Review translated automatically

Reliable opinion

2025-07-27, 08:46

View original

Eckehard

Good product delivered quickly. I searched for a while to avoid spending so much and found what I was looking for at GMOTO. That's how it should be.

Review translated automatically

Reliable opinion

2024-11-14, 06:14

View original

JAQUET

Ras oil filter I've been using for years, top of the range and inexpensive, the same thing a competing brand could do.

Review translated automatically

Reliable opinion

2024-10-13, 18:55

View original

hicham

Fast delivery to France ,Perfect for my 2016 Integra 750 top product I'll be ordering again soon.

Review translated automatically

Reliable opinion

2024-11-07, 08:28

View original

Furui

Delivered as ordered. Everything in order. I would order from GMoto again. It is a reliable supplier.

Review translated automatically

Reliable opinion

2025-05-13, 06:46

View original

Riders

Thank you very much...! All part it's OK..! I'm very happy with my order end accessory.... End fast delivery.!

Review translated automatically

Reliable opinion

2022-06-30, 23:54

View original

Maciej

Suzuki DR 350 1992 gaskets very well made, fit in the original lagi, installation seamless, recommend.

Review translated automatically

Reliable opinion

2022-05-02, 11:20

View original

Mirosław

Honda SW t400 year 2010 very good filter, very good workmanship, fits my Honda It met my expectations

Review translated automatically

Reliable opinion

2020-01-24, 08:51

View original

Tomasz

Recommended product very easy to install oring included without any problems recommend to all interested parties

Review translated automatically

Reliable opinion

2022-01-30, 08:29

View original

Andrzej

Honda CBF600 PC43 - has been using for years, quality is sufficient with annual oil change interval and quiet driving.

Review translated automatically

Reliable opinion

2020-06-30, 12:31

View original

Marcin

honda varadero xl100v all Balls gaskets super quality and easy to replace. i think the top shelf product

Review translated automatically

Reliable opinion