Motorcycle parts
Honda NSR 125 - Page 5

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2017-07-22, 11:04

View original

Adrian

Honda NSR 125 vintage 98. HEL brake line I purchased with safety in mind, the product definitely improves the quality and braking power. The workmanship of the cable and the ends is very good. The product fits perfectly in place of the original one and blends into the color scheme of the motorcycle. The only downside is the screws included in the kit, they have a larger thread pitch by which you must use the original ones. I highly recommend the purchase of this product.

Review translated automatically

Reliable opinion

2017-07-15, 09:23

View original

Dawid

2000 Honda CBR 600F. The regulator works as expected + good price. I had previously tested a custom-made regulator, purchased at reg_mot.republika.pl, and unfortunately found that it drew current at a standstill, and was quite a bit larger than the standard regulator and required rearranging the components under the fairing. Tour-max regulator is the same size as the original, works perfectly. I am satisfied, I recommend it!

Review translated automatically

Reliable opinion

2018-05-30, 16:49

View original

Krzysiek

I have a replica honda magna 2003 year 125ccm I was looking for rectifiers on the internet for a long time and finally found them here fast shipping I fired it up the first time good quality product solid I recommend it

Review translated automatically

Reliable opinion

2023-06-14, 02:35

View original

Mariusz

Installation: perfect fit to the frame holes (Honda CBR 600F4) Operation: charging at idle 13.4-13.7 V, maximum charging voltage 14.4-14.6 V (holds until cut-off, measured with a meter) The price is quite exorbitant, although the parameters reflect what it should be. Cheaper Chinese ones I'm afraid of, while here there is more confidence in the quality of the product.

Review translated automatically

Reliable opinion

2020-05-03, 00:23

View original

Maciej

Wsk 125 The frame is nice, you can't expect more from a plastic metallized one. It fits my wsk-i nicely. The only big minus is that it did not fit completely in the holes - I had to widen the holes with a drill both at the top and bottom. Other than that, installation was easy. I recommend the product for those who don't mind making up holes.

Review translated automatically

Reliable opinion

2019-10-18, 08:20

View original

Tycjan

Bmw R 1100 RT 2000 year, I purchased a set of consumables. Very friendly, professional service and advice. Competitive prices. They respond to emails. You are kept informed about the shipping status. This was my 3rd contact with the company. I recommend, I will certainly use again more than once. Regards, Tycjan

Review translated automatically

Reliable opinion

2021-05-08, 07:38

View original

Andrzej

Plastic license plate frame looks like a good chrome material I changed the plate because I became the owner of a Suzuki Intruder VL 125 2000 year all in all. Looks super material fine that's why the price very low ugly comes longer.

Review translated automatically

Reliable opinion

2020-06-07, 11:07

View original

Piotr

Good day, I own a Suzuki RM 125 and from the beginning I had problems with candles. Recommended cheaper replacements did not cope. Only replacing the candle with an iridium one solved the problem. Finally I stopped having problems with firing up, I recommend 100%!

Review translated automatically

Reliable opinion

2016-04-14, 08:25

View original

Andrzej

Honda XL125 Varadero. After replacement, the play in the suspension of the rocker arm was erased and the comfort of the ride increased. The part fit very well and very good quality. The store works accurately, very good contact, good prices-I recommend.

Review translated automatically

Reliable opinion

2024-07-30, 14:11

View original

Jakub

I previously owned a regular spark plug and bought an iridium one, the difference is colossal, the engine does not start, it is more sensitive to the accelerator, better acceleration, I recommend the product, it is worth paying extra for this spark plug.

Review translated automatically

Reliable opinion

2019-06-17, 07:58

View original

Damian

In the category of quality/price very nice frame. Strong plastic imitating chrome. Aesthetics at a high level. Lightweight and durable And the license plate enters on contact ( for me a plus because there is no slack). I recommend

Review translated automatically

Reliable opinion

2019-04-12, 07:04

View original

Rafal

I own a motorcycle Daelim Daystar vl 125 prod. year 2006 . Lag seals from ATHENA was a successful purchase because they eliminated leakage from the shock absorbers. Easy and quick installation.P olecam.

Review translated automatically

Reliable opinion

2017-09-04, 10:25

View original

Mariusz

frame very nice, put on jawa ts 350 looks very good on this motorcycle, installation also very pleasant immediately changes the name of the motorcycle adds better charm

Review translated automatically

Reliable opinion

2024-09-25, 05:27

View original

Filip

Very good solution for those who want to replace the license plate frame with a new one. The price is very affordable. The quality of workmanship is also flawless. I can recommend

Review translated automatically

Reliable opinion

2024-09-19, 07:03

View original

CHASLES

Fits new tubes without a hitch, and after several km on normal roads, no leaks to report. We'll have to wait and see how the rubber ages over time.

Review translated automatically

Reliable opinion

2025-04-13, 11:27

View original

NIKOS

Excellent product. It fit properly in the caliper and I no longer have any leakage from the wear and tear of the previous one. Tourmax quality comparable to the factory ones.

Review translated automatically

Reliable opinion

2017-06-18, 21:11

View original

Konrad

As great a plus as possible. The product in full working order, I recommend it as much as possible. I looked in many stores and here I found the cheapest. Price/quality 10/10.

Review translated automatically

Reliable opinion

2024-05-03, 08:21

View original

Magda

Sealers fit varadero 125 2002, workmanship ok, trouble-free installation. So far the suspension works ok, we'll see how long they last.

Review translated automatically

Reliable opinion

2023-06-26, 15:34

View original

Przemysław

Professional approach to the customer, assistance at every stage and reliable. Express service, quality at the highest level, great and close-knit team.

Review translated automatically

Reliable opinion

2023-05-31, 06:57

View original

Sylwester

I highly recommend these iridium plugs it is very durable and the motorcycle thanks to it has more power and collects better I recommend this plug for your 2T.

Review translated automatically

Reliable opinion

2022-04-24, 13:31

View original

Krystian

Motorcycle enduro Beta RR 50 delivery went smoothly Sealers easy to install and despite riding on heavy terrain do not let go I recommend highly.

Review translated automatically

Reliable opinion

2021-06-23, 21:07

View original

Łukasz

Goods very well packaged and protected in a clear box, you can see what you are buying made solidly and with good materials. Recommended.

Review translated automatically

Reliable opinion

2019-08-10, 14:00

View original

Wojciech

Yamaha tdr 125 2000. The plug works very well, it has a much better service life and the bike fires better when cold but the performance has not changed.

Review translated automatically

Reliable opinion

2025-09-18, 10:04

View original

ΔΗΜΗΤΡΗΣ

It has nickel finish but its plastic, the article says metallic but thats wrong, if you want it for enduro bike or adv its not metallic

Review translated automatically

Reliable opinion

2024-08-25, 09:15

View original

Wojciech Adamczyk

I highly recommend to everyone !!!!!! Very convenient and fast delivery and a large selection of parts the candle performs brilliantly !

Review translated automatically

Reliable opinion

2021-05-07, 20:08

View original

Paweł

Candle cool motor runs nice, smokes without problems, I recommend, a little expensive compared to a regular one but the investment should pay off.

Review translated automatically

Reliable opinion

2018-05-07, 18:15

View original

Magdalena

WSK M6 B3 1982 Very good quality product easy to install. Fits perfectly, looks very good. Frame worth recommending.

Review translated automatically

Reliable opinion

2022-03-22, 08:36

View original

Dawid

Candle perfect for diesel engines that heat up a lot, dissipates heat as it should, recommend for cross bikes

Review translated automatically

Reliable opinion

2017-06-23, 12:38

View original

leszek

The kit fits KMX 125 without any problems. 74zł is the cheapest option I found. I recommend. The motorcycle again goes where I want it to go.

Review translated automatically

Reliable opinion

2018-10-23, 18:45

View original

Karol

I own a 2004 Yamahe dt 50 r.The product made very well easy to install.The product did its job as much as possible.

Review translated automatically

Reliable opinion

2025-07-27, 08:46

View original

Eckehard

Good product delivered quickly. I searched for a while to avoid spending so much and found what I was looking for at GMOTO. That's how it should be.

Review translated automatically

Reliable opinion

2020-06-22, 12:22

View original

Karol

Works very well , everything as in the description. Great workmanship, with good quality materials, the motorcycle runs perfectly and has power

Review translated automatically

Reliable opinion

2020-06-22, 00:17

View original

Karol

Works very well , everything as in the description. Great workmanship, with good quality materials, the motorcycle runs perfectly and has power

Review translated automatically

Reliable opinion

2020-10-05, 22:26

View original

Tomasz

Suzuki rm 125 2000 vintage, candle very good works great improved the performance of my motorcycle I recommend it to everyone

Review translated automatically

Reliable opinion

2020-06-22, 02:22

View original

Karol

Works very well , everything as in the description. Great workmanship, with good quality materials, the motorcycle runs perfectly and has power

Review translated automatically

Reliable opinion

2023-08-14, 15:03

View original

Janek

I have not yet assembled and do not know how with the fragility of the plastic, but from the outside it looks positive. On the back a slight unpainting.

Review translated automatically

Reliable opinion

2020-05-04, 10:22

View original

Mirosław

BMW R1150 RT 2002 YEAR, the replacement went quickly and without any difficulties, gaskets very good according to my expectations

Review translated automatically

Reliable opinion

2022-12-24, 13:35

View original

Maksymilan

Iridium spark plug in super quality AND very affordable price, I have in my 125five,I am very satisfied with this product.

Review translated automatically

Reliable opinion

2025-09-10, 09:42

View original

Thomas

The part fitted perfectly. Everything as described and everything went great. Will order again if required.

Review translated automatically

Reliable opinion