Motorcycle parts
Honda NSR 50 - Page 3

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2024-10-09, 13:17

View original

Wiktor

It sits in my neos as well as simson and I can not say a bad word about it. If it wasn't good I wouldn't buy it a second time. I recommend

Review translated automatically

Reliable opinion

2020-04-12, 13:22

View original

Piotr

The product perfectly replaces the original part, after replacement the pump is tight. For this operation, it is worth buying a gasket and oring.

Review translated automatically

Reliable opinion

2020-12-25, 00:18

View original

Marcin

The product met my expectations, the workmanship is very good with no imperfections. The price is adequate to the quality, it is better to buy one for 15 than 3 for 5 Chinese, which will fall apart after 150 km of driving. Water resistance is, proved it to me last weather when I drove into a decent puddle at 50 km/h Hurricane did not even hesitate. Assembly slightly falls out to warm up on a radiator, because such a cold rubber from the courier to fit is a nightmare.

Review translated automatically

Reliable opinion

2021-09-13, 22:50

View original

Patryk

For Romet Zetta 50 fits like a glove - it looks identical to the Chinese original. The rubber cover on the side of the high-voltage cable, admittedly, is hard to enter the cable, but this is an advantage in my opinion - it reduces the risk of moisture getting inside. After installation, the difference is unbelievable, the spark on the spark plug has improved, it is strong, and there is no phenomenon of "falling ignition". I recommend!

Review translated automatically

Reliable opinion

2016-09-09, 10:49

View original

Rafał

I bought this kit in the store with the information that it may not fit the cbr 250 but I made an aluminum ring on the wall 0.65mm height 0.80 mm circumference 30.00mm inner circumference 28.70 and it fits the rest of the dimensions is the same thank you for reliable information seller price in the service is 240 PLN and the ring cost me 10 PLN at a friend turner and everything is fine I recommend

Review translated automatically

Reliable opinion

2020-05-31, 09:42

View original

Miklós

A weboldal tökéletes, minden igényt kielégítő. A szállítás még így is, hogy nemzetközi (Lengyel - Magyar) gyorsabb volt, mint sokszor Magyarországon belüli szállítás. A kifizetett alkatrészekről, a csomagom állapotáról folyamatos jelzést kaptam. Az alkatrészekkel 100 %-ban elégedett vagyok :-) *****+*

Review translated automatically

Reliable opinion

2014-09-11, 21:30

View original

Jerzy

I have been shopping with this seller for a long time and each time I am very satisfied with the quality, speed and contact with the seller. I have already recommended several offers to my friends, who are also very satisfied.

Review translated automatically

Reliable opinion

2020-06-29, 06:30

View original

Pawel

Conforms to the description , fast processing of the order , everything in the best order I RECOMMEND ptychol.

Review translated automatically

Reliable opinion

2017-04-28, 08:25

View original

Karolina

I bought these jaws for my Honda XR125 . It met my expectations, the description is in line with the facts. Fast hassle-free shipping, in a word-elegant. There is nothing to complain about! :)

Review translated automatically

Reliable opinion

2016-01-12, 20:17

View original

Rafał

Romet Ogar 205, year of production 1987.NGK is NGK, quality in itself, I changed and the firing problem disappeared. Pipe precisely made, matches the rest of the ignition system components.

Review translated automatically

Reliable opinion

2020-02-03, 14:49

View original

Patryk

Suzuki katana ay 50 (2006) The fit of the pipe is very good, the plug is designed for a candle without a cap, sealed ends prevent water from getting inside.

Review translated automatically

Reliable opinion

2023-07-28, 07:41

View original

Adam

Parts ok . Installed in Yamaha XT 660 X. However, it is also worth replacing the oil sealer which is not included in the set. Customer service super and shipping lightning fast.

Review translated automatically

Reliable opinion

2018-07-06, 13:55

View original

Karol

Cool brand NGK. Fits perfectly in place of the factory one, gives a good spark. Thanks to the 2 protectors do not get moisture in the wires and candle. I recommend !

Review translated automatically

Reliable opinion

2019-07-03, 21:51

View original

Krzysztof

Quality at a high level. Included are sealing rubbers so that water does not get under the spark plugs or between the high-voltage wire and the pipe.

Review translated automatically

Reliable opinion

2017-04-16, 21:04

View original

Grzegorz

Shl m11 1961. Nothing to add, nothing to take away, the pipe sits like this and the extra protective rubbers should protect well against water and possible punctures.

Review translated automatically

Reliable opinion

2021-08-13, 09:01

View original

Krzysztof

It works 100% pity only that the kit does not include a copper washer. To seal the connection. Other than that, the product is of good quality. I really recommend

Review translated automatically

Reliable opinion

2016-07-31, 17:56

View original

Dariusz

I bought 2 pipes for a Romet Pony and a Chinese Moto Ventus scooter for both of them, I also bought NGK plugs and the startup of the motos improved immediately

Review translated automatically

Reliable opinion

2017-07-23, 09:59

View original

Michał

It fits the ETZ 250 very well. It is made of rather good material, the plug sits firmly - there is no possibility of 'popping out'. I recommend.

Review translated automatically

Reliable opinion

2021-07-11, 12:02

View original

tomasz

Honda CLR 125 City Fly jaws fit perfectly,everything ok.Workmanship quality is very good new springs included also recommend.

Review translated automatically

Reliable opinion

2020-09-14, 20:18

View original

Grzegorz

Goods of the highest quality. Good workmanship fast delivery affordable price. I really recommend.Like a part and for a motorcycle it is only GMOTO!!!

Review translated automatically

Reliable opinion

2020-10-04, 21:49

View original

Wojciech

Romet ogar 205 What can I say pipe from a good company I use with all my motorcycles and there has never been a problem with them. I recommend

Review translated automatically

Reliable opinion

2016-06-19, 09:21

View original

Dominik

One of the few decent pipes available on the market. The spark jumps only between the electrodes of the candle and not where it wants.

Review translated automatically

Reliable opinion

2020-03-27, 07:47

View original

Mirosław

Honda Shadow VT600 1994. The rubber is not yet attached but, it should fit. the workmanship of these is of a high standard.

Review translated automatically

Reliable opinion

2024-05-04, 21:45

View original

Wojciech

Pipe made of good material. Made aesthetically and very accurately. You respect yourself respect your motorcycle too .Regards

Review translated automatically

Reliable opinion

2021-01-22, 11:01

View original

Jurek

Ignition pipe of good quality, it does not fall off, nothing happens to it, I own 3 such pieces and recommend them as much as possible.

Review translated automatically

Reliable opinion

2021-02-06, 20:03

View original

Sebastian

The pipe is nicely made, the rubber seals fit the candle well and I am sure that no water will get in. I recommend

Review translated automatically

Reliable opinion

2021-01-16, 08:41

View original

Damian

Piaggio Hexagon 125cm 1996 scooter. Very good quality product and very easy to install. Highly recommend.

Review translated automatically

Reliable opinion

2020-05-29, 08:34

View original

Grzegorz

Good quality, it's ok too short for me to say more, but workmanship at a satisfactory level

Review translated automatically

Reliable opinion

2019-05-18, 07:30

View original

Marcin

Product as described, well made, decently packaged in my opinion will serve a nice few years.

Review translated automatically

Reliable opinion

2024-05-03, 04:14

View original

Bartosz

Elegant pipe from 5 horses became 20 everything fits spark so that Poland could be powered pozdro

Review translated automatically

Reliable opinion

2023-07-03, 16:03

View original

Lola

Very good pipe, fits pit ganga 140 perfectly and works very well. I recommend very heartily.

Review translated automatically

Reliable opinion

2024-09-04, 08:31

View original

Błażej

Pipe super ( unlike NGK candles, for Romet)solidly made, holds firmly , I recommend

Review translated automatically

Reliable opinion

2021-03-15, 16:12

View original

Adam

Super 12/10 I recommend wholeheartedly nothing better anywhere than the products on gmoto. Best store.

Review translated automatically

Reliable opinion

2024-01-23, 07:45

View original

Antoni

I recommend the pipe does not fall down no puncture nice fit

Review translated automatically

Reliable opinion

2019-06-11, 19:22

View original

Paweł

Hello.I have a generic xor 50 and the ordered parts came quickly and are of good quality.Greetings and recommended

Review translated automatically

Reliable opinion

2017-06-18, 19:01

View original

Michal

The ignition pipe is not reprimanded, it works perfectly as all parts from GMOTO !!!

Review translated automatically

Reliable opinion

2021-02-16, 08:44

View original

Paweł

BMW K 100 Battery Cover Mounting Piece. Although dedicated to Honda it fits 100%. I recommend

Review translated automatically

Reliable opinion

2019-03-11, 20:54

View original

Piotr

Romet Ogar 202 72ccm I recommend it looks nice and is temperature and water resistant.

Review translated automatically

Reliable opinion

2023-12-12, 09:36

View original

Mateusz

I recommend this pipe because it has very good quality, it fits Aprilia RS125 and KTM EXC 250.

Review translated automatically

Reliable opinion