Forgot password
Order status
Free delivery from 150 euro
Browse by manufacturer
Products reviews
I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.
Review translated automatically
Reliable opinion
Honda Africa XRV 750 - 1999. I bought 12 pieces. This mounting rubber is found in several places on the motorcycle(the mount of the skull rack, oil cooler, plastic handles, etc.). It looks like the original, the rubber is flexible, you can bend it with two fingers with a stronger squeeze and it looks solid. Only the course of time can verify whether it is as solid. Dimensions: Hole diameter(nominal): 10mm Width of the entire rubber: 22mm Groove depth: 8mm
Review translated automatically
Reliable opinion
2000 Honda CBR 600F. The regulator works as expected + good price. I had previously tested a custom-made regulator, purchased at reg_mot.republika.pl, and unfortunately found that it drew current at a standstill, and was quite a bit larger than the standard regulator and required rearranging the components under the fairing. Tour-max regulator is the same size as the original, works perfectly. I am satisfied, I recommend it!
Review translated automatically
Reliable opinion
The mounting rubber of the exhaust manifold bracket, and the end muffler, fits tightly and stabilizes them very well, by the way, rumor has it that the TOURMAX brand manufactures OEM parts for HONDA motorcycles, and this can be seen, with disassembled worn parts (markings from casting molds).
Review translated automatically
Reliable opinion
The delivery was within the agreed deadline. The products arrived as pictured. Quality seems good.
Review translated automatically
Reliable opinion
Installation: perfect fit to the frame holes (Honda CBR 600F4) Operation: charging at idle 13.4-13.7 V, maximum charging voltage 14.4-14.6 V (holds until cut-off, measured with a meter) The price is quite exorbitant, although the parameters reflect what it should be. Cheaper Chinese ones I'm afraid of, while here there is more confidence in the quality of the product.
Review translated automatically
Reliable opinion
Sealers without complaint. In a rigid and secure package a set of sealers and covers for two leaguers. Assembly trivially easy (for those who like and have an idea of DIY and small repairs). The fit is perfect. So far zero problem and the lags work perfectly in combination with Motul 10W oil.
Review translated automatically
Reliable opinion
Honda ST 1300 2002 rubbers fit very good material, they look nice, not everyone remembers that due to worn out rubbers the grip of shoes to the footrests is low which makes it easy to have an accident, safety first and foremost and if by the way the machine gains in appearance it is even better ;)
Review translated automatically
Reliable opinion
My machine is an 86 Honda Shadow VT 1100 . Purchased parts were not dedicated for this vintage , so as a novice user I bought blind and surprisingly they fit . Installation was no problem and the material and workmanship flawless . G Moto and product on pistket . LWG .
Review translated automatically
Reliable opinion
Valve very carefully made and probably better than the original, very good because it has a filter, and if already some fleck comes with the fuel it will not get further. I recommend this product, I installed in my moto HONDA NTV and it is great, DEFINITELY RECOMMEND.
Review translated automatically
Reliable opinion
Patient Honda CB600F Hornet, vintage 2001, non-functioning fan switch. What can I say, a top-notch product. After replacement, the fan spins and works at its best. This radiator fan switch is a great product, I would recommend it to anyone
Review translated automatically
Reliable opinion
The product fit perfectly, I am extremely satisfied. The option from the website to specify the bike model and it tells you which product is suitable is great. The delivery was fast, they kept me informed all the time about the movement of the product.I recommend !
Review translated automatically
Reliable opinion
Honda Deauville, year 2008, poj.700.Workmanship solid, well-fitted, no problems with installation, meet expectations. We will see how long they will serve :-).It was worth buying, but a piece of rubber should not cost so much ;-).
Review translated automatically
Reliable opinion
Honda st 1300 2002 , the motorcycle has its years at the time of purchase of the machine and the first inspection it turned out that the pins are "worn out" new ones I could not find anywhere , of course on Gmoto there was no problem with the availability ;)
Review translated automatically
Reliable opinion
Good morning, I was looking everywhere for this particular replacement, but I only found it in this store. I am very happy with the quality of the product in relation to the price. It's worth it and more.
Review translated automatically
Reliable opinion
We fitted the bearings to a 2004 Honda Hornet pc36. The installation went smoothly and the bearings seem indestructible ;) Well, but this is Mc International after all, the top shelf among parts for Japanese ;)
Review translated automatically
Reliable opinion
The part is of very good quality, comparable to the original, everything fits as it should, works flawlessly, you can confidently drive a few seasons without looking, doing an average of up to 10,000 km per season
Review translated automatically
Reliable opinion
The above set of seals for front forks Honda Deauville NT 700 V, r.v. 2008 absolutely fine, trouble-free assembly, the product suits the type of moto, appears to be of good quality.
Review translated automatically
Reliable opinion
Honda CBR F4i 2003. The pins made correctly but if you have a motorcycle like me, they are only suitable from what I noticed for the battery case, the fairing already falls off .
Review translated automatically
Reliable opinion
VARADERO XL 1000 SD01 99r. Very good quality fuel pump repair kit. The installation went without any problems. Very good fit of the parts. I recommend the manufacturer and seller.
Review translated automatically
Reliable opinion
The protections, compared to the old ones, are slightly wider, more rigid and more "expandable", which makes them fit perfectly into the groove in the lade blocking the sealers.
Review translated automatically
Reliable opinion
This mounting rubber is a great replacement for the rubbers found on the Honda CBR 600, but they are slightly smaller than the original (I personally didn't mind the installation)
Review translated automatically
Reliable opinion
Honda Transalp xl650 2001 year. The installation of the gaskets went smoothly, good fit , good workmanship and material quality . After installation the carburetor works like new.
Review translated automatically
Reliable opinion
The motorcycle is a honda transalp 600 1996r.The element fit perfectly without any reservations thanks to good workmanship and fit the repair went quickly and efficiently.Regards
Review translated automatically
Reliable opinion
Bought to replace the original honda bearings, very good quality, fitted just right for the Hornet, very good price. Fast shipping, I recommend.
Review translated automatically
Reliable opinion
Great sealers, they fit nice and tight even though the lag was polished, so far only about 100km after replacement but no drop on the lag, I recommend
Review translated automatically
Reliable opinion
Excellent product. It fit properly in the caliper and I no longer have any leakage from the wear and tear of the previous one. Tourmax quality comparable to the factory ones.
Review translated automatically
Reliable opinion
I own a Honda NT650V Deauville. The seals seem solid because of the 2 spring rings. The previous ones only had one such ring.
Review translated automatically
Reliable opinion
I am very satisfied - the quality is really excellent and the delivery was lightning fast. Everything went smoothly. I will be happy to order again!
Review translated automatically
Reliable opinion
Parts corresponding to the original start at a slightly lower temperature 85/90 degrees original start at 100 degrees aesthetics equal to the original
Review translated automatically
Reliable opinion
On CBF 500A applied correctly to the radiator and it works just like the factory switch. It also seals as it should and there are no leaks.
Review translated automatically
Reliable opinion
Sealers well made, there was no problem with the installation which indicates well-behaved parameters. Tight, oil no longer leaks.
Review translated automatically
Reliable opinion
Sealers very good quality not some cheap plastic. There are 2 springs on each sealer. Fast shipping. Recommended.
Review translated automatically
Reliable opinion
Honda Cbr 1100 xx vintage 2005 I recommend this store. Everything without the slightest problem. The package came quickly. Well packaged.
Review translated automatically
Reliable opinion
Fit perfectly which I also expected. Would definitely recommend others to order. Relatively fast shipping, but ok
Review translated automatically
Reliable opinion
Product of good quality as always fast shipping art.I installed in Honda CB 750 Steven fifty degree of difficulty of installation 2/5 I recommend
Review translated automatically
Reliable opinion
Good product delivered quickly. I searched for a while to avoid spending so much and found what I was looking for at GMOTO. That's how it should be.
Review translated automatically
Reliable opinion
Suitable and functional seals. Fast service, reasonable prices and fast delivery. I am satisfied and will order again.
Review translated automatically
Reliable opinion
The seals fit suzuki gsx600f. Finally stopped leaking from the suspension and its operation improved significantly. I recommend
Review translated automatically
Reliable opinion
Perfect for my 2004 Hornet. They fit perfectly, good quality for a decent price. Perfect shipping.
Review translated automatically
Reliable opinion
Other models of
- Honda NT 650 V Deauville CBS 2003
- Honda NT 650 V Deauville 2001
- Honda NT 650 V Deauville CBS 2002
- Honda NT 650 V Deauville CBS 2002
- Honda NT 650 V Deauville 1998
- Honda NT 650 V Deauville 1998
- Honda NT 650 V Deauville 1999
- Honda NT 650 V Deauville 1999
- Honda NT 650 V Deauville 1999
- Honda NT 650 V Deauville 2000
- Honda NT 650 V Deauville 2000
- Honda NT 650 V Deauville 2000
- Honda NT 650 V Deauville 2001
- Honda NT 650 V Deauville 2001
- Honda NT 650 V Deauville CBS 2002
- Honda NT 650 V Deauville CBS 2004
- Honda NT 650 V Deauville CBS 2004
- Honda NT 650 V Deauville CBS 2004
- Honda NT 650 V Deauville CBS 2005
- Honda NT 650 V Deauville CBS 2005
- Honda NT 650 V Deauville CBS 2005