Motorcycle parts
Honda SH 300 - Page 4

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2018-11-01, 20:28

View original

Krzysztof

Honda Africa XRV 750 - 1999. I bought 12 pieces. This mounting rubber is found in several places on the motorcycle(the mount of the skull rack, oil cooler, plastic handles, etc.). It looks like the original, the rubber is flexible, you can bend it with two fingers with a stronger squeeze and it looks solid. Only the course of time can verify whether it is as solid. Dimensions: Hole diameter(nominal): 10mm Width of the entire rubber: 22mm Groove depth: 8mm

Review translated automatically

Reliable opinion

2019-01-12, 09:03

View original

Andrzej

Honda Cbf 500 2007. Sealers very good quality . Hassle-free installation. You can see at a glance that it is an original product of Athena.Oil burning I have already.I recommend.

Review translated automatically

Reliable opinion

2020-05-20, 09:29

View original

Hubert

The filter is very good. The price/quality ratio is at a very high level. I can confidently recommend as a replacement for the original parts.

Review translated automatically

Reliable opinion

2021-06-22, 08:54

View original

Sylwek

The filter of a very decent brand. I buy it all the time and have never been disappointed. A very big plus is that it can be unscrewed with a socket wrench. If someone has little space, as I do, to do anything at the filter then such a head on the filter is salvation. It is a little more expensive than the standard version but worth every penny. Last time I had a regular filter I had to perforate it and pour oil in the exhaust pipes to unscrew it , in this case the replacement was clean, fast and above all simple! I recommend

Review translated automatically

Reliable opinion

2022-09-28, 18:40

View original

Stanisław

Honda NTV 650 Revere 97r. Kit well made, good quality parts, easy installation good fit. Replaces the original parts well, the pump works flawlessly. I would like to add that the kit was purchased on the recommendation of a Honda service employee because the original repair kit costs almost 4 times as much, and this one does its job 100%. I sincerely recommend.

Review translated automatically

Reliable opinion

2025-08-03, 20:59

View original

Aksel

Have used these gaskets for the valve cover screws and they do exactly what they are supposed to. They seal tight, keep oil in and seem like a definite improvement over worn original gaskets. Installation was easy and the material feels both resilient and durable. No signs of oil sweat after installation - completely satisfied!

Review translated automatically

Reliable opinion

2023-05-24, 21:04

View original

Dariusz

very good product,easy to install,app to download,connects to your phone via blue tooth and you have everything on the screen of your phone,like charging current,battery condition,monitoring its performance and so on,very useful thing,highly recommend in good conscience

Review translated automatically

Reliable opinion

2017-07-11, 09:59

View original

Mariusz

I am a happy owner of a yamaha yzf 125r in which I recently noticed oil loss , I replaced the valve seals which I ordered from gmoto and I am very satisfied , solidly made . Easy to install and fit to my 2010r model I recommend to everyone.

Review translated automatically

Reliable opinion

2017-07-11, 09:59

View original

Mariusz

I am a happy owner of a yamaha yzf 125r in which I recently noticed oil loss , I replaced the valve seals which I ordered from gmoto and I am very satisfied , solidly made . Easy to install and fit to my 2010r modelj recommend to everyone.

Review translated automatically

Reliable opinion

2024-05-05, 17:43

View original

Wiesław

Filter as described hassle-free installation and a big plus for the ability to tighten with a wrench without using special wrenches for filters. Painting without cavities, and it looks aesthetically pleasing. Plus for the protective film on the filter inlet.

Review translated automatically

Reliable opinion

2024-09-20, 06:31

View original

Alexandros

Good morning, I was looking everywhere for this particular replacement, but I only found it in this store. I am very happy with the quality of the product in relation to the price. It's worth it and more.

Review translated automatically

Reliable opinion

2021-08-19, 23:45

View original

Eryk

I own a TORQ brand 50 cc moped from 2015, I decided to go with a higher voltage because it is required to replace the starter, after many attempts to do so, a new battery is a simpler and faster affair.

Review translated automatically

Reliable opinion

2022-08-02, 22:30

View original

Andrzej

I own a 2013 Honda Cb 500 F motorcycle. Pads very good quality, well packaged and I have already ridden are sharp and after reaching are braking well compared to the previous ones are sharper.

Review translated automatically

Reliable opinion

2023-09-11, 20:14

View original

sara

This mounting rubber is a great replacement for the rubbers found on the Honda CBR 600, but they are slightly smaller than the original (I personally didn't mind the installation)

Review translated automatically

Reliable opinion

2020-05-25, 08:45

View original

Jacek

Honda cbr 1100 xx, bearings for the wheel work great. Quality and fit ok. protection from water and dirt is much better than in the previously worn. I recommend.

Review translated automatically

Reliable opinion

2020-05-13, 06:44

View original

Damian

Honda VTX 1300 2006. The master cylinder was reconditioned with the kit purchased. Fast, efficient. High quality goods. The pump works like new.

Review translated automatically

Reliable opinion

2025-04-13, 11:27

View original

NIKOS

Excellent product. It fit properly in the caliper and I no longer have any leakage from the wear and tear of the previous one. Tourmax quality comparable to the factory ones.

Review translated automatically

Reliable opinion

2020-04-20, 09:38

View original

Adrian

Honda CB600 F Hornet, thanks to the possibility of using a ring wrench, the replacement went remarkably fast , it is worth paying a few zlotys extra for this convenience

Review translated automatically

Reliable opinion

2020-03-06, 07:17

View original

Mariusz

TRW pads are a brand in itself. There is nothing to complain about, they fit and work perfectly. Worthy of recommendation for all users.

Review translated automatically

Reliable opinion

2017-04-04, 23:05

View original

Piotr

Honda transalp 600v,1995. Universal kit , well fitted , works flawlessly. Quality of materials at a high level. I recommend .

Review translated automatically

Reliable opinion

2020-03-31, 10:10

View original

Krzysztof

The product shipped on time, b.well protected, everything efficiently, quickly and reliably , as described. I highly recommend, Krzysiek

Review translated automatically

Reliable opinion

2025-07-27, 08:46

View original

Eckehard

Good product delivered quickly. I searched for a while to avoid spending so much and found what I was looking for at GMOTO. That's how it should be.

Review translated automatically

Reliable opinion

2024-09-19, 06:25

View original

Γιώργος

Hilfo guarantee ! It also has the screw , so removing - adding is easy ! It is worth it compared to the simple filter !!!

Review translated automatically

Reliable opinion

2024-11-07, 08:28

View original

Furui

Delivered as ordered. Everything in order. I would order from GMoto again. It is a reliable supplier.

Review translated automatically

Reliable opinion

2020-10-12, 22:34

View original

Dawid

Good price for filters, it is not a pity to change the oil with filter every 4h. everything ok, you can confidently order without fear.

Review translated automatically

Reliable opinion

2022-05-02, 11:20

View original

Mirosław

Honda SW t400 year 2010 very good filter, very good workmanship, fits my Honda It met my expectations

Review translated automatically

Reliable opinion

2019-06-22, 19:15

View original

Grzegorz

Good product - the aphrodite stopped "buzzing" at higher speeds. I also have the impression that it got a bigger kick ;)

Review translated automatically

Reliable opinion

2018-09-23, 12:23

View original

Wojtek

Honda crf 250R 2008. Good filter i have been using it since i got my motorcycle and it works well i have no problem with it :)

Review translated automatically

Reliable opinion

2018-11-22, 19:44

View original

Andrzej

Honda Transalp XL 600 1999. Rubber installed fits it is not orginal but can be goes in its place .

Review translated automatically

Reliable opinion

2023-05-19, 05:35

View original

Jeremiasz

Very nice workmanship with good strong material fits the caliper perfectly works well on KTM SX 125

Review translated automatically

Reliable opinion

2019-04-20, 12:46

View original

Gabriel

Very good quality and workmanship the fit is also ok as I the very way of putting on the valves is quite simple

Review translated automatically

Reliable opinion

2021-04-05, 10:10

View original

Krzysztof

Honda ST 1300 year 2004 Product very well made replacement went without a problem. Rating very good.

Review translated automatically

Reliable opinion

2024-05-03, 08:20

View original

Krzysztof

It fits and works, and thanks to its special design, it makes replacement much easier. All you need is an ordinary socket wrench.

Review translated automatically

Reliable opinion

2024-06-08, 22:37

View original

Kacper

Everything fits as expected, good quality product, there was no problem with the fit and installation.

Review translated automatically

Reliable opinion

2021-04-26, 10:15

View original

Adam

Complies with the description. Everything ok. nice contact, efficient shipping, everything went quickly and smoothly.

Review translated automatically

Reliable opinion

2023-06-30, 12:51

View original

Rafał

Recommended. The product is consistent with the photo. Carefully packed in foil, you can see that no one rummaged at it.

Review translated automatically

Reliable opinion

2022-05-29, 20:11

View original

Jacek

Honda Varadero 125, a part worth recommending, fits, workmanship good, everything works as expected.

Review translated automatically

Reliable opinion

2021-06-23, 21:09

View original

Łukasz

Seal protection solidly made, I can say that even better than the originals. I recommend.

Review translated automatically

Reliable opinion

2018-04-03, 22:30

View original

Bartłomiej

The rubbers fit and hold everything in place. Quality of fit and workmanship without any reservations.

Review translated automatically

Reliable opinion