Motorcycle parts
Honda VF 750 C Magna 2000

2018-11-01, 20:15

View original

Krzysztof

I ordered the air vents with the motorcycle Honda XRV 750 Africa Twin - 1999 in mind. They fit the front calipers as well as the rear caliper. After screwing in, there is a little bit of thread sticking out(this is for a small minus), which is covered by a blanking rubber. They successfully replace the original, which is twice as expensive in the service. To the aesthetics and solidity rather can not be complained about - no burrs, the layer of zinc is placed on well-prepared steel. When tightening, care should be taken to select a perfectly matching wrench, scratches and destruction of the zinc layer can result in the appearance of rust in a fairly short time due to the fact that the material is steel. The downgrade for the material is due to the fact that I would prefer stainless steel instead of steel and zinc.

Review translated automatically

Reliable opinion

2018-11-01, 20:28

View original

Krzysztof

Honda Africa XRV 750 - 1999. I bought 12 pieces. This mounting rubber is found in several places on the motorcycle(the mount of the skull rack, oil cooler, plastic handles, etc.). It looks like the original, the rubber is flexible, you can bend it with two fingers with a stronger squeeze and it looks solid. Only the course of time can verify whether it is as solid. Dimensions: Hole diameter(nominal): 10mm Width of the entire rubber: 22mm Groove depth: 8mm

Review translated automatically

Reliable opinion

2025-09-22, 15:11

View original

Jordi

Honda Cb500 PC26 - 1994 Includes the parts needed to repair the front brake master cylinder. These are not the original Honda parts, but they are good quality and fit the brake pump perfectly.

Review translated automatically

Reliable opinion

2018-05-30, 16:49

View original

Krzysiek

I have a replica honda magna 2003 year 125ccm I was looking for rectifiers on the internet for a long time and finally found them here fast shipping I fired it up the first time good quality product solid I recommend it

Review translated automatically

Reliable opinion

2024-09-20, 12:07

View original

Aurélien

Purchased to completely rebuild my Nissin 11mm master cylinder. The kit fits perfectly. My master cylinder is back for life.

Review translated automatically

Reliable opinion

2022-09-28, 18:40

View original

Stanisław

Honda NTV 650 Revere 97r. Kit well made, good quality parts, easy installation good fit. Replaces the original parts well, the pump works flawlessly. I would like to add that the kit was purchased on the recommendation of a Honda service employee because the original repair kit costs almost 4 times as much, and this one does its job 100%. I sincerely recommend.

Review translated automatically

Reliable opinion

2020-03-30, 20:41

View original

Michał

Sealers without complaint. In a rigid and secure package a set of sealers and covers for two leaguers. Assembly trivially easy (for those who like and have an idea of DIY and small repairs). The fit is perfect. So far zero problem and the lags work perfectly in combination with Motul 10W oil.

Review translated automatically

Reliable opinion

2020-07-08, 19:23

View original

Waldemar

My machine is an 86 Honda Shadow VT 1100 . Purchased parts were not dedicated for this vintage , so as a novice user I bought blind and surprisingly they fit . Installation was no problem and the material and workmanship flawless . G Moto and product on pistket . LWG .

Review translated automatically

Reliable opinion

2017-05-15, 22:44

View original

Maciej

Patient Honda CB600F Hornet, vintage 2001, non-functioning fan switch. What can I say, a top-notch product. After replacement, the fan spins and works at its best. This radiator fan switch is a great product, I would recommend it to anyone

Review translated automatically

Reliable opinion

2024-09-20, 06:29

View original

Alexandros

Good morning, I was looking everywhere for this particular replacement, but I only found it in this store. I am very happy with the quality of the product in relation to the price. It's worth it and more.

Review translated automatically

Reliable opinion

2024-09-20, 06:31

View original

Alexandros

Good morning, I was looking everywhere for this particular replacement, but I only found it in this store. I am very happy with the quality of the product in relation to the price. It's worth it and more.

Review translated automatically

Reliable opinion

2025-07-02, 08:12

View original

Iñaki

It works correctly and was very easy to install. My bike is a 2006 CBF600N and I had no problems at all, it only takes a socket wrench and needle nose pliers to remove and attach the connecting cable.

Review translated automatically

Reliable opinion

2017-11-17, 07:02

View original

Jakub

We fitted the bearings to a 2004 Honda Hornet pc36. The installation went smoothly and the bearings seem indestructible ;) Well, but this is Mc International after all, the top shelf among parts for Japanese ;)

Review translated automatically

Reliable opinion

2021-06-03, 15:15

View original

Sławomir

I own a 2005 Honda CBF600. The sensor fit without a problem, plug and play. The replacement took 5 minutes. Fulfillment of the order was lightning fast, the product was with me the next day. Highly recommend.

Review translated automatically

Reliable opinion

2025-09-02, 18:25

View original

Tomáš

The above set of seals for front forks Honda Deauville NT 700 V, r.v. 2008 absolutely fine, trouble-free assembly, the product suits the type of moto, appears to be of good quality.

Review translated automatically

Reliable opinion

2020-03-30, 20:44

View original

Michał

The protections, compared to the old ones, are slightly wider, more rigid and more "expandable", which makes them fit perfectly into the groove in the lade blocking the sealers.

Review translated automatically

Reliable opinion

2025-07-15, 05:30

View original

KARLOS

Same as the original, but 75% cheaper. Quick response to e-mails. Although with a little more delay in delivery with respect to what was said on the page.

Review translated automatically

Reliable opinion

2023-09-11, 20:14

View original

sara

This mounting rubber is a great replacement for the rubbers found on the Honda CBR 600, but they are slightly smaller than the original (I personally didn't mind the installation)

Review translated automatically

Reliable opinion

2025-09-25, 07:32

View original

Славчо

They did a perfect job for me.The delivery was fast and accurate.And the workmanship itself is perfect the quality is top,the site is very good and accurate and quality which is the most important thing

Review translated automatically

Reliable opinion

2020-05-13, 06:44

View original

Damian

Honda VTX 1300 2006. The master cylinder was reconditioned with the kit purchased. Fast, efficient. High quality goods. The pump works like new.

Review translated automatically

Reliable opinion

2025-04-30, 17:05

View original

Thomas

Bought to replace the original honda bearings, very good quality, fitted just right for the Hornet, very good price. Fast shipping, I recommend.

Review translated automatically

Reliable opinion

2024-05-03, 07:48

View original

Bogusław

Great sealers, they fit nice and tight even though the lag was polished, so far only about 100km after replacement but no drop on the lag, I recommend

Review translated automatically

Reliable opinion

2025-04-13, 11:27

View original

NIKOS

Excellent product. It fit properly in the caliper and I no longer have any leakage from the wear and tear of the previous one. Tourmax quality comparable to the factory ones.

Review translated automatically

Reliable opinion

2019-08-26, 12:15

View original

Sławomir

I own a Honda NT650V Deauville. The seals seem solid because of the 2 spring rings. The previous ones only had one such ring.

Review translated automatically

Reliable opinion

2017-06-18, 21:11

View original

Konrad

As great a plus as possible. The product in full working order, I recommend it as much as possible. I looked in many stores and here I found the cheapest. Price/quality 10/10.

Review translated automatically

Reliable opinion

2025-08-07, 09:58

View original

Vincent

Parts corresponding to the original start at a slightly lower temperature 85/90 degrees original start at 100 degrees aesthetics equal to the original

Review translated automatically

Reliable opinion

2025-07-22, 11:06

View original

Stefanos

On CBF 500A applied correctly to the radiator and it works just like the factory switch. It also seals as it should and there are no leaks.

Review translated automatically

Reliable opinion

2021-08-13, 09:01

View original

Krzysztof

It works 100% pity only that the kit does not include a copper washer. To seal the connection. Other than that, the product is of good quality. I really recommend

Review translated automatically

Reliable opinion

2023-05-24, 07:13

View original

Remi

Sealers well made, there was no problem with the installation which indicates well-behaved parameters. Tight, oil no longer leaks.

Review translated automatically

Reliable opinion

2020-02-11, 17:50

View original

Piotr

Sealers very good quality not some cheap plastic. There are 2 springs on each sealer. Fast shipping. Recommended.

Review translated automatically

Reliable opinion

2017-04-04, 23:05

View original

Piotr

Honda transalp 600v,1995. Universal kit , well fitted , works flawlessly. Quality of materials at a high level. I recommend .

Review translated automatically

Reliable opinion

2025-05-13, 07:11

View original

Kenn

Fit perfectly which I also expected. Would definitely recommend others to order. Relatively fast shipping, but ok

Review translated automatically

Reliable opinion

2025-04-23, 06:01

View original

Jens

Fast service. Good place to shop and at a really good price. They ship fast. It's not the last time I shop there.

Review translated automatically

Reliable opinion

2023-07-29, 07:17

View original

Sika

Product of good quality as always fast shipping art.I installed in Honda CB 750 Steven fifty degree of difficulty of installation 2/5 I recommend

Review translated automatically

Reliable opinion

2025-07-27, 08:46

View original

Eckehard

Good product delivered quickly. I searched for a while to avoid spending so much and found what I was looking for at GMOTO. That's how it should be.

Review translated automatically

Reliable opinion

2024-06-22, 08:03

View original

Rafał

The seals fit suzuki gsx600f. Finally stopped leaking from the suspension and its operation improved significantly. I recommend

Review translated automatically

Reliable opinion

2025-01-12, 17:44

View original

Barlet

Perfect for my 2004 Hornet. They fit perfectly, good quality for a decent price. Perfect shipping.

Review translated automatically

Reliable opinion

2024-09-11, 14:40

View original

Marcin

Very good quality workmanship fit perfectly to the lags 2 sets mounted on Moto and miles fly nothing leaks.

Review translated automatically

Reliable opinion

2024-11-07, 08:28

View original

Furui

Delivered as ordered. Everything in order. I would order from GMoto again. It is a reliable supplier.

Review translated automatically

Reliable opinion

2021-04-09, 17:18

View original

Piotr

Recommended. 100% satisfaction. Full compatibility. Fast delivery, seamless transaction. Thank you and best regards.

Review translated automatically

Reliable opinion